Sealey Satin Paint 500ml - Black
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Sealey Black Satin Aerosol Spray Paint is designed for DIY enthusiasts and professionals seeking a durable and easy-to-apply finish on metal, wood, and plastic surfaces. Its key benefit is outstanding covering power with a fast-drying, fade-resistant satin finish. A potential caveat is the need for proper surface preparation and priming for optimal adhesion.
All features
| Colour | Black |
|---|---|
| Model Part Number | SCS028S |
| Brand | Sealey |
Extended Product Information
FAQs
What surfaces can this paint be used on?
This paint is suitable for use on primed metal, wood, and plastic surfaces.
How long does the paint take to dry?
The paint is fast-drying, but specific drying times can vary depending on temperature, humidity, and application thickness. Allow sufficient time between coats.
How do I prevent the nozzle from clogging?
After each use, turn the can upside down and spray for a few seconds to clear the nozzle. Store the can properly after use.
Do I need to use a primer?
Yes, using a suitable primer is recommended for optimal adhesion and a durable finish, especially on metal and plastic.
What is the finish of this paint?
The paint provides a satin finish, which is a smooth, non-glossy appearance.
How should I clean up spills or overspray?
Clean up wet paint immediately with a suitable solvent. Dried paint may require scraping or sanding.
What is the recommended spray distance?
Hold the can upright, approximately 25-30 cm (10-12 inches) from the surface.
Troubleshooting
Uneven spray or sputtering
Ensure the can is shaken thoroughly for at least 2 minutes. If blockage persists, try clearing the nozzle by turning the can upside down and spraying. Clean the nozzle with a solvent if necessary.
Paint not adhering well
The surface may not have been properly prepared. Ensure it is clean, dry, and free from contaminants. Use a suitable primer before application.
Runs or drips
The paint was applied too thickly or held too close to the surface. Apply in thin, even coats and maintain the recommended distance.
Poor coverage
Ensure the can was shaken sufficiently and applied evenly. Multiple thin coats usually provide better coverage than one thick coat.
Pros and Cons
Pros
- Excellent adhesion to primed surfaces.
- Durable and long-lasting finish.
- Fast-drying formula saves time.
- Resistant to colour fade, maintaining appearance.
- Suitable for a wide range of materials (metal, wood, plastic).
Cons
- Requires a primed surface for best results.
- Satin finish may not be suitable for all aesthetic preferences.
- Aerosol application requires good ventilation.
- 500ml can size might be too large for very small touch-ups.
Setup, Compatibility & Care
Setup:
- Ensure the surface to be painted is clean, dry, and free from grease, oil, and loose paint. Sand lightly if necessary and apply a suitable primer for optimal adhesion.
- Shake the can vigorously for at least 2 minutes after the rattling begins.
- Hold the can upright, approximately 25-30 cm (10-12 inches) from the surface.
- Apply paint in smooth, even strokes, overlapping each pass slightly. Use a steady back-and-forth motion.
- Apply in a well-ventilated area, away from ignition sources.
Compatibility:
- Suitable for use on primed metal, wood, and plastic surfaces.
- Always test on an inconspicuous area first, especially on plastics, to ensure compatibility.
Care:
- Store the can in a cool, dry place, away from direct sunlight and heat.
- After use, turn the can upside down and spray for a few seconds to clear the nozzle. Failure to do so may result in blockages.