Sealey Paint - Silver 500ml - SCS031S




Currently unavailable




Currently unavailable
This Sealey Silver Paint (SCS031S) is designed for DIY enthusiasts and professionals seeking a durable, fast-drying finish on various surfaces. Its key benefit is outstanding coverage and adhesion, making projects efficient. A potential caveat is its suitability primarily for primed surfaces to achieve optimal results.
| Colour | Silver |
|---|---|
| Model Part Number | SCS031S |
| Brand | Sealey |
This paint is designed for use on a range of metals, wood, and plastic. For optimal adhesion and durability, it is recommended to apply to primed surfaces.
The paint is fast-drying. Specific drying times can vary based on application thickness and environmental conditions, but it allows for quicker recoating.
Yes, the paint is formulated to be resistant to colour fade, ensuring the silver finish maintains its appearance over time.
Ensure the surface is clean, dry, and free from grease. Applying a compatible primer before painting is highly recommended for best adhesion and a durable finish.
Yes, the paint provides a tough, durable finish resistant to colour fade, making it suitable for outdoor applications on appropriate materials.
Hold the can upright, approximately 25-30 cm from the surface for best results and to avoid runs or drips.
If the nozzle becomes clogged, turn the can upside down and spray for a few seconds. If blockage persists, carefully remove the nozzle and clean with a suitable solvent, then reattach and test.
Ensure the can is thoroughly shaken. Check that the nozzle is not clogged. If clogged, clean according to can instructions, usually by briefly spraying upside down or using a fine pin.
The surface may not have been properly prepared or primed. Ensure the surface is clean, dry, and a compatible primer was used. Reapply after proper surface preparation.
Applied paint too thickly or held can too close to the surface. Apply in lighter, more even coats from the recommended distance.
Inadequate coverage or uneven application. Ensure sufficient coats were applied evenly. Check for consistent spray pattern and distance.
Preparation: Ensure the surface is clean, dry, and free from grease or contaminants. For best results, apply to a primed surface. If not primed, ensure the primer used is compatible with metal, wood, or plastic as appropriate.
Application: Shake the can thoroughly before use. Apply in a well-ventilated area. Hold the can upright, approximately 25-30 cm from the surface. Apply in light, even coats, allowing sufficient drying time between each coat.
Compatibility: Suitable for use on a range of metals, wood, and plastic. Always test on an inconspicuous area first to ensure compatibility and desired finish.
Care: Store in a cool, dry place away from direct sunlight and sources of ignition. Clean up spills or excess paint immediately with appropriate thinners (refer to product label for specific recommendations).