Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This guide is for DIY enthusiasts and homeowners looking to protect and enhance exterior metal surfaces. The Hammerite Direct To Rust Metal Paint Aerosol in Silver offers a time-saving, all-in-one primer, undercoat, and topcoat solution with up to 8 years of rust protection and a distinctive hammered finish. A key caveat is its solvent-based composition, requiring good ventilation and careful handling.
| Colour | Silver |
|---|---|
| Model Part Number | 5084783 |
| Brand | Hammerite |
While technically possible, it is not recommended due to its strong solvent-based composition, high VOC content, and requirement for excellent ventilation. It is best suited for exterior applications.
The paint offers up to 8 years of rust protection and corrosion resistance when applied correctly according to instructions.
No, this product is specially formulated to be applied directly onto rusty surfaces. Its 3-in-1 formula acts as primer, undercoat, and topcoat.
One can covers approximately 0.5 m².
After painting, turn the can upside down and spray for 2 seconds. This will clear any paint from the nozzle and prevent it from becoming blocked.
Use in a well-ventilated area, wear appropriate personal protective equipment (gloves, eye protection), and keep away from heat, sparks, and open flames. Contains flammable components and can cause eye irritation or drowsiness.
Yes, but you must first apply a coat of Hammerite Special Metals Primer before applying the Hammered Metal Paint for proper adhesion.
Ensure the can has been shaken vigorously for at least 3 minutes. Invert the can and spray briefly after use to clear the nozzle. If the nozzle is blocked, try cleaning it with a thin wire or solvent.
The spray was likely too close to the surface or too much paint was applied in one go. Apply lighter coats from a greater distance (around 15 cm) and keep the can moving.
The surface may not have been prepared correctly, or the underlying paint is incompatible. Ensure loose rust and contaminants are removed. For new or incompatible surfaces, refer to the 'Surface Preparation' section, especially for zinc, aluminium, or galvanised metal. Conduct a test patch.
Ensure the correct number of coats (3-4) are applied. The effect is subtle and builds with subsequent layers.
Check if the nozzle is blocked. Try cleaning it or using a new can. Ensure the can is upright when spraying (unless clearing the nozzle).
Preparation is key for optimal performance. For best results, store the aerosol can at room temperature for at least 2 hours before use.
Surface Preparation:
Application:
Compatibility:
Care:
