Johnstone's Washable Paint - Green

This paint is designed for interior walls and ceilings. It provides excellent coverage and durability on common interior surfaces such as plaster, plasterboard, and previously painted walls.

Info needed: [coverage per litre]. Typically, a 2.5L can of Johnstone's Washable Matt Paint can cover approximately 25-30 square meters with two coats, depending on the porosity and texture of the surface.

This paint is quick-drying. It is typically touch dry within 1-2 hours, and you can usually apply a second coat after 2-4 hours. Always refer to the specific label instructions for precise drying and recoat times.

Yes, its washable and durable nature makes it suitable for areas prone to splashes and marks, like kitchens and bathrooms. However, for areas with very high and continuous humidity, a specialized kitchen/bathroom paint with enhanced mould resistance might offer additional benefits.

Gently wipe the mark or spill with a soft, damp cloth using plain water. For more stubborn marks, a very mild solution of diluted household detergent can be used, followed by a wipe with a clean, damp cloth. Avoid abrasive cleaners, harsh chemicals, or scrubbing.

Priming is highly recommended for new plaster, bare surfaces, or walls that are significantly discoloured or damaged to ensure optimal adhesion, coverage, and a uniform finish. For previously painted surfaces in good condition, a thorough cleaning is often sufficient, but priming can still enhance results.

This means the paint's unique formulation allows you to clean off marks and spills without the surface becoming glossy or losing its original matt appearance. The durable film resists absorption and damage, preserving the aesthetic integrity even after cleaning.

Ensure the surface was properly prepared, clean, and primed if necessary. Stir the paint thoroughly before and during use. Apply paint in thin, even coats, allowing each coat to dry completely before applying the next. Avoid overspreading the paint.

Wipe spills and marks as soon as possible. Use only a soft, damp cloth with plain water or a very mild, diluted detergent. Avoid abrasive sponges, harsh chemicals, or excessive scrubbing, as these can compromise the matt finish and durability.

While low odour, ensure adequate ventilation during and after painting by opening windows and doors. The odour should dissipate completely as the paint fully cures. Cooler, humid conditions may prolong odour retention.

Check the room temperature and humidity. Extreme heat can cause paint to dry too quickly, leading to brush marks, while high humidity or low temperatures can slow down drying. Maintain conditions within the recommended range (10°C to 28°C).

Ensure the surface is completely dry before painting. Bubbles can form if paint is applied over a damp surface or if a too-thick coat is applied. Improper surface preparation (e.g., dust, grease) can also cause adhesion issues. Allow paint to dry, sand smooth, and reapply.