Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
Hammerite Direct To Rust Metal Paint is a specialized solvent-based solution designed for homeowners and DIY enthusiasts looking to protect and revitalize exterior metal surfaces like railings, gates, and garden furniture. Its primary benefit is the 3-in-1 formula that acts as a primer, undercoat, and topcoat, allowing you to paint directly over rust for a significant time-saving finish; however, it is strictly intended for outdoor use and requires specific preparation for non-ferrous metals like zinc or aluminum.
| Colour | Black |
|---|---|
| Model Part Number | 5158237 |
| Brand | Hammerite |
No, this product is specifically formulated for outdoor use and should not be used in interior settings.
For previously painted metal in sound condition, one coat is often enough. For bare or rusty metal, two coats are required for optimal protection.
The paint is touch-dry within one hour, but you should wait at least four hours before applying a second coat.
For most ferrous metals, no. The 3-in-1 formula acts as its own primer. However, you do need a special primer for aluminum, zinc, or galvanized surfaces.
Use Hammerite Brush Cleaner & Thinners to clean your brushes after removing as much excess paint as possible.
The product label warns against skin contact. If exposed, wash thoroughly and consult the product safety information; if you feel unwell after inhalation, move to fresh air immediately.
You have likely over-applied the paint. Use lighter, thinner coats and ensure even coverage without loading the brush too heavily.
Remove the old paint entirely before applying Hammerite, as the test patch indicated an incompatibility with the underlying layer.
Hammerite requires a specialized primer for galvanized or aluminum surfaces. Apply the primer first, then follow with the Hammerite coat.
Before starting your project, ensure your surface is clean, dry, and free of grease. For previously painted metal, perform a test patch first—if there is no reaction after one hour, you can apply the paint directly.
Special surface considerations:
