PlastiKote - Green - PKT1296

The PlastiKote Metal Protekt spray dries to the touch in approximately 1 hour. Allow 15-20 minutes between coats for best results.

For best results, remove loose rust and lightly sand the surface. For heavily rusted areas, consider applying a metal primer specifically designed for rusty surfaces before using the Metal Protekt spray.

Shake the can well, hold it about 10-12 inches from the surface, and apply in thin, even coats with a steady back-and-forth motion, overlapping each stroke. Avoid applying too thickly in one go.

Yes, the PlastiKote Metal Protekt spray is designed for both interior and exterior surfaces, providing long-lasting protection against rust and corrosion.

It is generally recommended to apply 2-3 thin, even coats for optimal coverage and protection. Ensure adequate drying time between each coat.

Yes, once fully cured, the PlastiKote Metal Protekt spray can be overcoated with most types of paint. However, it's always advisable to test compatibility on a small, inconspicuous area first.

Shake the can more vigorously. Ensure the nozzle is not clogged. Try applying from a slightly different distance or angle.

Surface was not properly cleaned or prepared. Ensure the metal was free of rust, grease, and dirt before application. Consider using a primer.

Applied too thickly or from too close. Apply in thin, even coats and allow adequate drying time between them. Remove drips with a cloth while wet, or sand and reapply once dry.

Nozzle may be clogged. Clear the nozzle by removing it and soaking it in a solvent like lacquer thinner, then dry thoroughly before reattaching. Ensure the can has sufficient propellant.