Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
The Hammerite Direct To Rust Metal Paint Aerosol is designed for DIY enthusiasts and professionals seeking a efficient way to restore and protect metal surfaces such as fences and furniture. Its primary benefit is the 3-in-1 formulation that acts as a primer, undercoat, and topcoat in one, providing up to 8 years of corrosion resistance. Please note that this product is solvent-based and intended for outdoor use only, and as an age-restricted item, it requires ID verification upon purchase.
| Colour | Black |
|---|---|
| Model Part Number | 5092965 |
| Brand | Hammerite |
No, this product is specifically formulated for outdoor use due to its solvent-based composition.
For maximum protection, apply 3 to 4 light, even coats.
No, this product is designed to be applied directly over rusty surfaces, though you should remove any loose or flaking material with a wire brush.
The minimum drying time is 1 hour, with a maximum drying time of 2 hours, and you can recoat after 15 minutes.
No, it contains flammable hydrocarbons and must be kept out of reach of children at all times.
The can is a pressurized container and may burst if heated; keep it away from heat, sparks, and open flames, and never store it in temperatures exceeding 50 degrees Celsius.
Ensure you invert the can and spray for 2 seconds after every use. If already clogged, check if the nozzle can be cleaned with a solvent-compatible thinner.
If a test patch shows a reaction, you must remove all old paint from the surface before applying Hammerite.
Verify the material is not bare zinc, aluminum, or galvanized. These surfaces require an additional primer step before applying the aerosol.
Before use, store the can at room temperature for at least 2 hours to ensure optimal spray consistency. Shake the can vigorously until you hear the agitator ball, then continue for 3 full minutes.
Compatibility note: While effective on most metals, bare zinc, aluminum, or galvanized surfaces require a specific metal primer before application. Always perform a test patch on previously painted surfaces; if there is no reaction after one hour, you may proceed. To care for the dispenser, always invert the can and spray for 2 seconds after each use to clear the nozzle and prevent future blockages.
