Merrell Moab Speed 2 Boots - Leather - UK 4.5

The Moab Speed 2 Boots are designed for fast hiking and lighter backpacking trips. While they offer good support, they may not provide the same level of ankle support and robust cushioning as heavier, dedicated backpacking boots for extensive, off-trail expeditions with very heavy loads.

These boots typically require a minimal break-in period due to their construction. Wear them around the house for short periods with your usual hiking socks. Gradually increase the duration and intensity of wear on short walks before embarking on longer hikes.

The stack height is 34mm at the heel and 24mm at the forefoot, resulting in a heel-to-toe drop of 10mm.

A single boot weighs approximately 385 grams.

Yes, the boots come with a removable EVA foam footbed and a removable PU foam insole. You can replace these with your own preferred insoles or custom orthotics if needed.

These boots are ideal for moderate trails, rocky paths, muddy conditions, and general hiking where a balance of grip, stability, and lightweight comfort is desired. They perform well in both wet and dry conditions due to their waterproof membrane.

Wipe away loose dirt with a soft brush or damp cloth. For tougher grime, use a mild soap and water solution. Ensure you allow the boots to air dry naturally and consider applying a suitable waterproofing treatment afterwards.

Loosen the laces and re-tie, ensuring an even distribution of pressure. Consider wearing thicker hiking socks for a snugger fit or thinner socks if they feel too constricting. If discomfort persists after break-in, ensure you have the correct size and width.

Check for any visible damage to the waterproof membrane or seams. Ensure the tongue gussets are properly aligned to prevent water ingress. If the boots have been submerged for extended periods, some moisture may seep through. Allow boots to dry completely and consider re-treating the exterior with a waterproofing agent.

Clean the Vibram sole thoroughly to remove mud, dirt, or debris that may be lodged in the lugs. Inspect the lugs for excessive wear; if significantly worn down, the grip may be compromised. Ensure you are using the boots within their intended performance parameters.

Utilize the Cleansport NXT treatment by ensuring good ventilation after each use. Remove insoles to dry separately. Sprinkle baking soda inside the boots overnight to absorb odors, then empty thoroughly before wearing. Regular cleaning will also help manage odor.