Golfers are always on the lookout for the best new golf clubs. But when it comes to golf grips, most golfers are still using the grips they played 5, 10, or even 15 years ago. And that’s because golf grips have remained essentially unchanged over the years. JumboMax grips are different… first and foremost because they’re bigger. Our claim is simple. Once you try JumboMax, you’ll never go back to “skinny grips.” The JumboMax Tour Series Golf Grip helps golfers improve their rhythm and smooth out their tempo with an ultra-stable construction that acts as a counterweight. With their increased mass, Tour Series grips can help golfers accelerate their hands through the impact area with less effort. This can help some golfers overcome tendencies such as an “early release” that lead to poor shots. Other golfers prefer the Tour Series for its extra-firm design that delivers maximum stability for the tightest possible shot dispersion. JumboMax Tour Series Golf Grip - Features: A Major Winner: Used By Bryson DeChambeau Promotes Light Even Grip Pressure Creates faster clubhead speed Ultra-Stable Super-Oversized Profile Improves clubface awareness and control Counter-Balanced Design Helps golfers smooth out their swing Twist-Resistant StabilityCore Offers maximum performance Ergonomic Shape: Allows for more practice and less pain Multibuy Discounts 5% Off 2 Grips - 10% Off 3 or more Grips Authorised JumboMax Retailer STEP-BY-STEP REGRIPPING INSTRUCTIONS The following supplies are needed: 1.PRO-GRIP DOUBLE SIDED GRIP TAPE 2.STANLEY KNIFE / BLADE 3.NEW GOLF GRIP 4.SOLVENT WHITE SPIRITS 5.RUBBER GLOVES TO PROTECT HANDS 6. TOWEL / CLOTH STEP 1 - Remove the old grip with a Stanley blade Be sure to cut away from yourself at all times. Peel or scrape off the old grip and grip tape. Using a cloth and Mineral Spirits Grip Solvent, clean off the residue. *If removing a grip from a graphite shaft be careful to avoid damage to the shaft STEP 2 - Wrap your PRO-GRIP double sided grip tape in a spiral formation from the top of the shaft to the point where the bottom of the grip will be on the shaft. Remove the tape backing and cover the end of the shaft with extra tape. STEP 3 - Cover the vent hole in the butt end with your finger or golf tee, and pour a generous portion of Solvent such as white spirits inside the new grip. Close the open end of the grip with your hand and shake to cover the entire inside of the grip. STEP 4 - Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs. STEP 5 - Place the grip over the shaft butt and Push the grip entirely onto the club. Be sure to push it all the way down and align the grip as desired. This must be done while the grip tape is still wet. STEP 6 - Allow grips to dry for several hours before playing.