CDA EIN60FSI Integrated Cooker Hood - Grey - B

Currently unavailable

Currently unavailable
This guide is for users of the CDA EIN60FSI integrated cooker hood, designed to provide effective ventilation while seamlessly integrating into your kitchen design. The key benefit is its ability to remove smoke, grease, and odors with a maximum extraction power of 193 m³/h. However, note that while it offers both ducted and recirculating options, the efficiency and performance can vary based on the chosen installation method.
| Colour | Grey |
|---|---|
| Energy Efficiency | B |
| Model Part Number | EIN60FSI |
| Brand | CDA |
The aluminum grease filter can be removed and cleaned either by hand with warm, soapy water or in a dishwasher.
Charcoal filters should be replaced every 3 to 6 months depending on usage.
Install the hood at a minimum height of 700mm above gas hobs and 600mm above electric hobs.
The hood uses a halogen bulb.
Yes, the hood supports both ducted and recirculating modes. You will need to install charcoal filters for recirculating mode.
Check and clean the grease filter and ensure that the ducting is not blocked (if ducted). Check the extraction speed setting.
The cooker hood requires a 3A power supply.
Replacement charcoal filters (CHA15) can be purchased from various appliance retailers or online.
Check the power supply and ensure the unit is correctly plugged in. Also, check the fuse.
Check the grease filter for blockages and clean it. Ensure the ducting is not blocked (if ducted).
Check the bulb and replace if necessary. The bulb type is halogen.
Ensure that the hood is installed correctly and that the ducting is properly connected (if applicable). Check the speed setting; lower speeds are quieter.
Ensure that the charcoal filters (if installed) are not saturated and replace them if needed. Clean the grease filter.