Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This guide is for anyone using Silverhook Big Boy Lightweight Body Filler to repair and smooth surfaces on cars, wood, metal, or rigid plastics. The key benefit is its easy application and excellent sanding properties, saving you time and effort. However, note that proper surface preparation is crucial for optimal results.
| Model Part Number | BIG01 |
|---|---|
| Brand | Silverhook |
The filler typically dries overnight, but always refer to the manufacturer's instructions for the specific drying time, which depends on temperature and humidity.
Yes, it is suitable for use on rigid plastics. However, ensure the plastic surface is properly prepared.
Use a range of sandpaper grits, starting with a coarser grit to remove excess filler and then progressing to finer grits for a smooth finish.
Yes, it's corrosion resistant and suitable for exterior use. Ensure it's fully cured before painting.
Store in a cool, dry place, away from direct sunlight and heat, with the lid tightly sealed.
Wear appropriate safety equipment, including gloves and eye protection. Work in a well-ventilated area, and avoid inhaling dust during sanding.
Once cured, the filler can be removed by sanding. If it's not cured, it can be removed with a scraper before it hardens.
Ensure you have mixed the filler and hardener in the correct ratio. Check the expiry date and ensure the products are not too old. The ambient temperature may be too low, allowing more time for curing.
Allow the filler to cure for the recommended time. Use appropriate sandpaper grit for the job.
Apply the filler in thin layers, allowing each layer to dry before applying the next. Avoid overfilling in one go.
Ensure the surface is clean, dry, and properly prepared with adequate sanding. Use an appropriate primer before painting.
Setup:
Compatibility:
Care:
