Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This premium 6mm toughened glass kitchen splashback from Warren Reed - Designer is for homeowners looking to add both style and practical protection to their kitchen walls. Its key benefit is the striking high-resolution geometric print on durable, easy-to-clean glass, creating a focal point. A caveat is that it requires specific adhesive for installation, not included.
| Model Part Number | W700mm X H650mm |
|---|---|
| Brand | Warren Reed - Designer |
You must use Clear Natural Curing Adhesive specifically designed for glass splashbacks. Follow the adhesive manufacturer's instructions carefully.
Yes, it is suitable for use behind most gas and electric hobs, as it is heat resistant up to 400°C. Ensure there is adequate ventilation if required by your hob manufacturer.
Clean with a soft cloth and a mild, non-abrasive kitchen cleaner. Wipe dry with a clean cloth to prevent streaks.
This particular model is 700mm wide and 650mm high (W700mm X H650mm).
Yes, the high-resolution print is applied to toughened glass and is designed to be durable and resistant to heat and cleaning.
The splashback comes with a 1-year guarantee.
No, toughened glass cannot be cut after manufacturing. Please measure carefully and choose the size that fits your space.
Ensure the wall is clean, dry, and flat. Verify that the correct Clear Natural Curing Adhesive was used and applied according to its instructions. Check that the adhesive has fully cured.
Use a non-abrasive cleaner and a soft microfiber cloth. Rinse the surface thoroughly with clean water and dry immediately with a separate clean cloth to prevent streaks.
Avoid using abrasive cleaning tools or harsh chemicals. If minor scratches occur, they may be less noticeable from a distance. Significant scratches may require replacement.
Setup:
Installation is designed to be straightforward. Ensure the wall surface is clean, dry, and smooth before application. Use Clear Natural Curing Adhesive specifically recommended for glass splashbacks. Apply the adhesive evenly to the back of the splashback or directly to the wall as per adhesive instructions. Carefully position the splashback and press firmly to ensure good contact. Allow the adhesive to cure fully according to the product's instructions before use.
Compatibility:
This splashback is suitable for installation behind most standard cooktops, including gas and electric. It is designed for wall mounting and is compatible with most wall types when the correct adhesive is used. Ensure the intended area is free from obstructions and electrical outlets where direct heat might be excessive or installation difficult.
Care:
To maintain the pristine appearance of your splashback, clean regularly with a soft, damp cloth and a mild, non-abrasive kitchen cleaner. Avoid using harsh chemicals, abrasive pads, or scouring agents, as these can scratch or damage the glass surface. For stubborn marks, a solution of warm water and mild soap can be effective.
