Finish Line Fiber Carbon Grip - 50G
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Finish Line Fiber Carbon Grip is designed for cyclists using carbon fiber components, offering a secure grip to prevent slippage and eliminate the need for over-tightening clamps. Its key benefit is enhancing safety and protecting delicate carbon surfaces. A potential caveat is that its effectiveness depends on proper, thin application.
All features
| Model Part Number | 36121610026 |
|---|---|
| Brand | FINISH LINE |
Extended Product Information
FAQs
How much Finish Line Fiber Grip should I use?
Apply a thin, even film to all clamping areas. Avoid over-application; a little is sufficient to create the necessary friction.
Can I use this on aluminum or steel components?
This product is specifically designed for carbon fiber components. For aluminum or steel, standard grease is generally recommended.
How often should I reapply Fiber Grip?
Reapply whenever components are removed for maintenance, adjustments, or after a significant period of use, especially if you notice any potential for slippage.
What is the shelf life of Fiber Grip?
When stored properly in a cool, dry place with the cap tightly sealed, Fiber Grip typically has a long shelf life. However, avoid using if the gel appears to have dried out or changed consistency.
Does Fiber Grip help prevent creaking noises?
While its primary function is to prevent slippage, by ensuring a secure and correctly torqued connection, it can indirectly help reduce noise caused by components moving against each other.
Can I use this with a torque wrench?
Yes, using Fiber Grip allows you to achieve the correct torque specification more reliably, preventing over-tightening which can damage carbon components.
Troubleshooting
Component still slips after applying Fiber Grip
Ensure the surfaces were clean and dry before application. Reapply a thin, even layer of Fiber Grip and tighten bolts to the correct torque specification using a torque wrench.
Difficulty in spreading the gel evenly
Apply a smaller amount of gel at a time and use a clean fingertip or a small brush to spread it into a thin, consistent film over the contact area.
Gel seems to have dried out in the tube
Ensure the cap was fully sealed after the last use. If it's still usable but slightly dry, try adding a tiny drop of water and mixing thoroughly, but for best results, consider replacing old product.
Pros and Cons
Pros
- Enhances safety by preventing component slippage.
- Protects carbon fiber components from damage caused by over-tightening.
- Ensures a secure and stable fit for critical bike parts.
- Easy to apply with a fast-absorbing gel texture.
- Suitable for a wide range of carbon fiber bicycle parts.
Cons
- Requires careful, thin application for optimal performance.
- May need reapplication after maintenance or component removal.
- Effectiveness can be reduced if applied too thickly or unevenly.
- Not suitable for non-carbon fiber components.
Setup, Compatibility & Care
Setup: Ensure the surfaces of both the component (e.g., handlebar, seatpost) and the clamp (e.g., stem, seat tube clamp) are clean and dry before application. Open the tube and apply a thin, even film of the Fiber Grip gel to the areas that will be in contact under the clamp. Avoid applying excessively; a little goes a long way. Assemble the component and tighten the clamp bolts to the manufacturer's recommended torque specifications using a torque wrench.
Compatibility: This product is specifically designed for use with carbon fiber-to-carbon fiber or carbon fiber-to-metal interfaces where friction is critical. It is compatible with stems, handlebars, seat posts, seat tubes, and other clamped carbon bicycle components.
Care: Store the Fiber Grip in a cool, dry place, away from direct sunlight. Ensure the cap is securely closed after each use to prevent the gel from drying out. If components are removed for maintenance or adjustments, it is recommended to clean the old grip material off both surfaces and reapply a fresh, thin layer of Fiber Grip.