Liqui Moly Pro-Line Throttle Valve Cleaner is a special active solvent designed for removing typical contamination and deposits found in the intake and throttle valve areas. It effectively loosens and removes contaminants such as oil, resin, and glue, ensuring the operability of all moving parts and increasing the operational reliability of gasoline-powered engines. This cleaner is suitable for the intake and throttle valve area, including nozzles and holes, and is intended for use in gasoline engines only. It offers excellent cleaning effects, is simple to use, and has been tested for use with catalytic converters, optimizing economical use. Cleaning can be performed without dismantling and allows for rapid cleaning. Application: Create direct access to the throttle valve. Start the engine to begin cleaning. Spray the Throttle Valve Cleaner across the entire area of the throttle valve in intervals of 2 – 3 seconds at a minimum of 2,000 revolutions via the spray probe. If the engine cannot maintain the speed with the intake pipe removed or cannot be started, disconnect the plug from the air flow meter with the ignition switched off. In this case, the stored fault must be deleted from the engine control unit after cleaning using a suitable diagnostic device, and the air flow meter must be taught in again if necessary. If a speed fluctuation of more than 1,000 revolutions occurs during application, it is important to shorten the spray intervals. Make sure that the Throttle Valve Cleaner does not come into contact with the air flow meter or painted components. In the case of stubborn deposits on the throttle valve, in the intake manifold or on the intake valves, cleaning can be repeated with a second can. After use, allow the engine to run for about 20 seconds at a minimum of 2,000 revolutions to burn any residues remaining in the intake system.