Araldite Standard Epoxy Adhesive Twin Tube - 2 x 15ml - Yellow
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
Araldite Standard Epoxy Adhesive is designed for professionals and DIY enthusiasts who require a high-strength, permanent bond for demanding repair projects. This two-part system provides an exceptional, long-lasting hold across a wide variety of materials, though it is important to note that its extended 80-minute working time requires patience as the adhesive cures slowly to reach maximum strength.
All features
| Colour | Yellow |
|---|---|
| Brand | Araldite |
Extended Product Information
FAQs
How long does it take to fully cure?
While the working time is 80 minutes, the adhesive usually requires several hours to reach initial handling strength and up to 24 hours for a full, permanent cure.
Can this be used outdoors?
Yes, it is resistant to temperature extremes from -30°C to 80°C, making it suitable for many outdoor applications provided it is not constantly submerged in water.
Is the adhesive clear after it sets?
No, Araldite Standard sets to a yellow finish, so it is best used in applications where the bond line will be hidden.
What should I do if I get glue on my skin?
Wash the affected area immediately with warm soapy water. Do not use solvents on the skin.
Can I paint over the cured epoxy?
Yes, once the adhesive is fully cured, it can be sanded and painted to match the surrounding material.
Troubleshooting
Adhesive remains tacky after 24 hours.
This is usually caused by incorrect mixing ratios. Ensure an equal length of resin and hardener is used and mixed thoroughly until the color is consistent.
Bond failed to hold on plastic surface.
Some plastics like polyethylene or polypropylene are difficult to bond with standard epoxy. Verify the material type; if it is a low-energy plastic, you may need a specialized primer.
Pros and Cons
Pros
- High-strength permanent bond suitable for structural repairs
- Versatile compatibility with diverse materials
- Generous working time allows for precise alignment
- Durable against chemical exposure and temperature fluctuations
Cons
- Requires manual mixing of two parts which may be inconvenient for small tasks
- Long cure time means projects cannot be rushed
- Yellow tint may be visible on certain light-colored surfaces
Setup, Compatibility & Care
To begin, squeeze equal lengths of resin and hardener from the twin tubes onto a clean, non-porous surface. Mix thoroughly until the mixture reaches a uniform yellow consistency. Apply the adhesive to one or both surfaces being joined, press them together, and clamp if necessary.
- Compatibility: Suitable for metal, wood, ceramics, glass, masonry, rubber, and most rigid plastics. Note that it is not intended for polyethylene or polypropylene.
- Storage: Store the tubes with caps tightly sealed in a cool, dry place. Keep the tubes upright to prevent leaking.
- Care: Wipe away any excess adhesive immediately with a cloth dampened with a solvent or acetone before it begins to cure.