DJI Surfing Tether - DJI
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The DJI Osmo Action Surfing Tethers are essential accessories for surf photographers and action sports enthusiasts who want to prevent camera loss while riding waves. Designed specifically for the DJI ecosystem, this tether system secures your camera to your surfboard, providing peace of mind during high-intensity water activities; however, it is strictly for flat surfaces and requires a clean, dry application to maintain a secure bond.
All features
| Brand | DJI |
|---|
Extended Product Information
FAQs
Can I use this on a curved surfboard deck?
No, the tether mount is specifically designed for flat surfaces to ensure a complete adhesive bond.
How long should I wait before surfing after applying the mount?
You should wait at least 30 minutes for the adhesive to set after pressing it onto the board.
Which DJI cameras are compatible?
The tether is compatible with Osmo Action 3, DJI Action 2, Osmo Action 4, Osmo Action 5 Pro, and Osmo 360.
What is the weight of the tether?
The tether mount weighs approximately 6 grams.
What temperature range can it withstand?
The ideal attachment temperature range is between -10° and 40° C (14° to 104° F).
Troubleshooting
Mount adhesive is peeling off
Ensure the board was cleaned thoroughly of all wax and salt before application. Avoid applying to curved areas.
Camera feels insecure
Check that the tether loop is properly secured to the camera body and the mount is firmly adhered to the board.
Pros and Cons
Pros
- Ultra-lightweight design adds minimal drag
- Highly compatible with a wide range of DJI action cameras
- Provides critical security for equipment in rough water conditions
- Easy to install on flat surfboard surfaces
Cons
- Not suitable for curved surfboard surfaces
- Requires a 30-minute set time before water use
- Single-use adhesive mount base
Setup, Compatibility & Care
To set up your tether, ensure the mounting surface on your surfboard is completely clean and free of wax or salt residue. Remove the adhesive backing and press the mount firmly onto a flat area of the board for at least 10 seconds. Crucially, allow the adhesive to cure for 30 minutes before exposing it to water. The ideal operating temperature range for the tether is -10° to 40° C (14° to 104° F). Avoid applying to curved sections of the board, as this prevents a full surface bond and compromises the integrity of the mount.