EVO STIK STRONG STUFF ULTIMATE STRENGTH GRAB ADHESIVE - White - 200ml
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone needing a strong, versatile adhesive for interior and exterior projects. EVO-STIK Strong Stuff provides an instant hold on various materials, from wood to plastics, even in damp conditions. A key benefit is its ability to bond non-porous materials, however, application time is limited to 10 minutes, so plan accordingly.
All features
| Colour | White |
|---|---|
| Brand | B&Q |
Extended Product Information
FAQs
What materials can I bond with EVO-STIK Strong Stuff?
It bonds to wood, metal, brick, glass, plaster, ceramics, and plastics.
Can I use it outdoors?
Yes, it is suitable for both interior and exterior use.
Can I use it on wet surfaces?
Yes, the adhesive bonds to wet surfaces.
How long do I have to adjust the position after application?
You have up to 10 minutes to adjust the position.
How long does it take to fully cure?
It takes approximately 24 hours to fully cure.
Is it safe to use?
Yes, it is a solvent-free and low-odour formula.
Can I paint over it?
Yes, it can be overpainted once fully cured.
Troubleshooting
Adhesion failure.
Ensure surfaces are clean and properly prepared. Roughen non-porous surfaces for better adhesion. Make sure that the correct amount of adhesive has been used.
Slow curing time.
Ensure the adhesive is applied within its recommended temperature range. Avoid excessive moisture during the curing period.
Pros and Cons
Pros
- Strong, instant hold.
- Bonds a wide range of materials.
- Suitable for both interior and exterior use.
- Can be used on wet surfaces.
- Low odour formula.
Cons
- Limited application time (10 minutes).
- Requires proper surface preparation for optimal adhesion.
- Curing time of approximately 24 hours.
Setup, Compatibility & Care
- Surface Preparation: Ensure surfaces are clean, dry, and free from dust, grease, and loose materials. For best results, lightly abrade non-porous surfaces.
- Application: Apply the adhesive to one surface, then immediately bring the surfaces together.
- Application Time: You have up to 10 minutes to position the materials correctly.
- Curing: Allow 24 hours for full curing. Avoid stressing the bond during this time.
- Compatibility: Compatible with wood, metal, brick, glass, plaster, ceramics, and plastics. Test on an inconspicuous area first, especially with sensitive materials.
- Care: Store in a cool, dry place. Avoid extreme temperatures. Wipe away any excess adhesive immediately with a damp cloth.