Tetrion Make Good™ Seal & Waterproof. For flat roofs, asphalt, gutters & pipework. For use on metal, walls, PVC & tarmac in all weather conditions. Exterior use only Black bitumen base Seals leaks instantly Prevents water ingress Doesn’t run or sag Tetrion Make Good™ Seal & Waterproof is an abrasion resistant and durable coating which gives effective, heavy duty protection and sealing power to flat roofing, metal panels and even vertical surfaces. It is formulated from a black bitumen base. Tetrion Make Good™ Seal & Waterproof is designed to provide a thick film without runs and sags. It gives excellent protection from stones, moisture and provides a barrier from water and dampness. Tetrion Make Good™ Seal & Waterproof offers corrosion protection, excellent adhesion to metal, gutters, driveways, pipework and a protective overcoat for sheds. It is water resistant and can be applied in all weather conditions. Tetrion Make Good™ Seal & Waterproof offers the following features: Soft healing, non-drying film Prevents water ingress Sound deadening Black bitumen base Does not run or sag Excellent adhesion Application: Remove all loose dirt & debris from the area to be coated. If required, clean and thoroughly dry the area. Remove any previous surface coatings with wire brush & abrasive paper. Lightly sand with a finer abrasive paper to give a good key and re-clean & dry. Shake aerosol can vigorously for 2 minutes minimum. Firstly test spray on a small inconspicuous area, to check spray rate, pattern and compatibility. Apply in short, even, light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry in between coats. If spray button clogs, invert can and spray to release. Clean overspray and spillages before coating dries, with white spirit-type solvent. Paint film should be touch dry in 2-3 hours and through-dry in 5-6 hours. Exterior use only. Cannot be overpainted. Tetrion Seal and Waterproof is a visco-elastic and abrasion resistant coating which gives effective protection and sealing power to flat roofing, metal panels and even vertical surfaces. It is thixotropic, meaning thick films can be quickly achieved. It gives excellent protection from water ingress and dampness. It cannot be overpainted. + Exterior use only + Black bitumen base + Seals leaks instantly + Prevents water ingress + Doesn’t run or sag Size: 400ml Usage Instructions: 1. Remove all loose dirt and debris from the area to be coated. If required, clean and thoroughly dry the area. .