Oetiker PG159 CV Boot Clamps - HCV20
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Oetiker PG159 CV Boot Clamps are essential components for automotive technicians and DIY mechanics looking for a reliable, permanent fastening solution for CV boots. These clamps offer a broad 40-110mm size range, ensuring a secure fit on various drive axle configurations while providing visible evidence of a proper seal upon installation. While these clamps are highly effective at maintaining a tight grip under demanding conditions, it is important to note that they require a specialized ear-clamping tool for proper installation and are intended for single-use applications.
All features
| Model Part Number | HCV20 |
|---|---|
| Brand | Mehr |
Extended Product Information
FAQs
Can I reuse these clamps if I need to adjust the boot?
No, these are permanent clamps designed for single-use only. Once the ear is deformed for installation, it cannot be safely reused.
Do I need a special tool to install these?
Yes, you need a CV boot ear-clamp pliers or a dedicated ear-clamping tool to properly crimp the ear.
Are these suitable for high-temperature environments?
Yes, the metal construction is designed to withstand typical automotive under-car temperatures and rotational heat.
What is the smallest diameter this clamp can handle?
This clamp is designed for applications ranging from 40mm to 110mm.
How do I know if the clamp is tight enough?
You can confirm a correct installation by observing the deformation of the clamp's ear. If it is pinched as designed, it is secured.
Troubleshooting
Clamp feels loose after installation
Ensure the clamping tool was fully compressed to deform the ear. If the ear is not sufficiently deformed, the clamp will not provide the required radial pressure.
Clamp ear snapped during installation
This may occur if the tool is misaligned or if excessive force is applied. Always use a proper ratcheting or manual ear-clamp tool and ensure the clamp is positioned squarely in the groove.
Grease leaking from under the clamp
Verify that the clamp is placed directly over the seating groove of the CV boot. If the boot is torn or the groove is damaged, replace the boot before installing a new clamp.
Pros and Cons
Pros
- Wide size range covers almost all common CV boot diameters
- Easy to verify correct installation via visible ear deformation
- High-strength materials ensure a long-lasting, permanent hold
- Prevents grease leakage effectively in harsh automotive conditions
Cons
- Requires a specific ear-clamping tool for proper installation
- Designed for single-use; cannot be reused once removed
- Not suitable for applications requiring periodic adjustment
Setup, Compatibility & Care
To install these clamps, slide the clamp over the CV boot and position it within the designated groove. Use a dedicated CV boot ear-clamping tool to squeeze the 'ear' of the clamp until it reaches the desired closure point. The clamp is properly secured when the ear deformation is visible, indicating that the clamp has achieved its maximum grip. Because these are permanent fastening components, they are not designed for removal and re-installation; if a mistake occurs during installation, the clamp must be discarded and replaced with a new one to ensure the integrity of the CV joint seal.