Polypipe Waste SC125 Solvent Cement - 125ml
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone using Polypipe Solvent Cement (125ml, SC125) for joining non-pressure PVC and ABS pipes. This solvent cement provides a strong, reliable bond essential for plumbing and drainage systems. However, proper application and surface preparation are critical for achieving a leak-proof seal.
All features
| Model Part Number | SC125 |
|---|---|
| Brand | Polypipe |
Extended Product Information
FAQs
What types of pipes is this cement compatible with?
This solvent cement is designed for use with non-pressure PVC and ABS pipes and conduits.
How long should I hold the pipe and fitting together after applying the cement?
Hold the pipe and fitting together firmly for 15-30 seconds after application.
How long should I wait before testing the system?
Allow the joint to cure fully, typically for about 24 hours, before applying pressure or testing the system. Refer to the product label for specific recommendations.
How should I store the solvent cement?
Store the solvent cement in a cool, dry place and ensure the container is tightly closed.
Is this cement suitable for pressure pipes?
No, this solvent cement is not suitable for use with pressure pipes.
What should I do if the cement gets on my skin?
If the solvent cement comes into contact with your skin, wash the affected area immediately with soap and water.
Troubleshooting
Joint leaks after assembly.
Ensure the pipe and fitting surfaces were clean before application. Re-apply cement and reassemble, holding firmly for the recommended time. Check for cracks in the pipes.
Cement appears too thick or difficult to apply.
Ensure the product has been stored correctly. If the product is old, it may have thickened. Ensure surfaces are clean before applying.
Pros and Cons
Pros
- Strong and reliable bonding for PVC and ABS pipes.
- Thixotropic formula for ease of use and reduced mess.
- Specifically designed for plumbing and drainage applications.
- Provides a durable and leak-proof seal when applied correctly.
Cons
- Requires proper surface preparation for optimal bonding.
- Can be messy if not handled carefully.
- Not suitable for pressure pipes.
- Bonding effectiveness depends on ambient temperature and humidity.
Setup, Compatibility & Care
- Preparation: Clean the surfaces of the PVC or ABS pipes thoroughly. Remove any dirt, grease, or moisture.
- Application: Apply a generous and even coat of solvent cement to both the inside of the fitting and the outside of the pipe.
- Assembly: Immediately insert the pipe fully into the fitting and hold it firmly for 15-30 seconds to allow the cement to set.
- Curing: Allow the joint to cure fully according to the manufacturer's instructions before applying pressure or testing the system. Usually, this is about 24 hours.
- Compatibility: This cement is compatible with non-pressure PVC and ABS pipes. Always check the pipe manufacturer's specifications for compatibility.
- Care: Store in a cool, dry place. Avoid contact with skin and eyes. Ensure adequate ventilation when using.