Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This guide is for small businesses and home offices looking for a compact and powerful server solution. The HPE ProLiant MicroServer Gen10+ v2 offers excellent performance and security in a small form factor, making it ideal for various applications. Keep in mind that while it's designed for ease of use, some technical knowledge may be required for initial setup and configuration.
| Series | ProLiant MicroServer Gen10+ |
|---|---|
| Model Part Number | P54649-421 |
| Brand | HPE |
The standard warranty typically covers a period of one to three years, depending on the specific configuration and service agreement. Refer to the product documentation or contact HPE support for the specific warranty details.
Yes, the server supports up to 64GB of DDR4 ECC UDIMM memory. You can add or replace RAM modules to increase the server's memory capacity.
The server supports 3.5-inch SATA hard drives. SSDs can also be used for improved performance.
You can access the iLO interface through a web browser using the server's dedicated iLO IP address. The default credentials are often available in the server's documentation or on a sticker on the server itself. Be sure to change the default password.
No, the HPE ProLiant MicroServer Gen10+ v2 does not have a dedicated slot for a graphics card.
No, the server does not support hot-swap hard drives.
The server supports Microsoft Windows Server, Red Hat Enterprise Linux (RHEL), and VMware vSphere.
Check the power cable and outlet. Ensure the power supply switch is turned on. Also, check the server's internal components for any loose connections.
Verify the network cables are securely connected. Check the network settings in the iLO interface and operating system. Ensure the network drivers are properly installed.
Check CPU and memory usage in the operating system. Ensure sufficient RAM is installed. Consider upgrading storage to SSDs. Clean any dust from internal fans to prevent overheating.
Ensure the iLO port is connected to the network. Verify the network settings in the iLO configuration. Reset iLO to factory settings if necessary.
Access the RAID configuration utility during server boot. Verify the RAID configuration. Check the status of the hard drives. Rebuild the array if needed.
