HB Body 2K Polyester Spray Filler Kit - HB260
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The HB Body 2K HB260 Polyester Spray Filler Kit is designed for professional automotive technicians and advanced DIYers who need a reliable solution for leveling surface imperfections before painting. Its primary benefit is providing a high-build, easily sandable surface that ensures a smooth finish for topcoats; however, users should be aware that as a two-component product, it requires precise mixing and has a limited pot life once the hardener is added.
All features
| Model Part Number | HB260 |
|---|---|
| Brand | HB Body |
Extended Product Information
FAQs
What nozzle size should I use for HB Body 2K HB260?
You should use a spray nozzle size between 2.50mm and 3.0mm to ensure proper flow and coverage.
Can I use this product on plastic parts?
This product is primarily designed for metal automotive bodywork; consult the technical data sheet for specific compatibility if applying to plastic or composite substrates.
How long does the product last once mixed?
As a 2K product, it has a limited pot life. It must be applied promptly after mixing with the hardener; check the label for the specific pot life duration in your climate.
Do I need to sand the surface before applying the filler?
Yes, ensure the surface is properly prepped and sanded according to standard automotive bodywork procedures to ensure maximum adhesion.
Is the 50ml hardener included in the kit?
Yes, the kit includes 1 Litre of spray filler and the 50ml hardener required for the curing process.
What grit sandpaper should I use after application?
After the filler has fully cured, it is designed to be sanded easily; start with a medium grit and finish with a fine grit (e.g., 400-600) to prepare for painting.
Troubleshooting
Filler is not curing properly.
Verify the mixing ratio between the filler and the 50ml hardener and ensure the ambient temperature in the workspace is within the manufacturer's recommended range.
Spray gun is clogging during application.
Ensure your spray nozzle is within the 2.50mm - 3.0mm specification and check if the product was mixed thoroughly; if it has exceeded its pot life, it will begin to thicken in the gun.
Surface finish appears rough or orange-peeled.
Adjust the air pressure on your spray gun or increase the nozzle size slightly; ensure the application distance is consistent to avoid dry spray.
Pros and Cons
Pros
- Excellent filling capabilities for minor surface defects
- Easy to sand, reducing manual labor during prep work
- Includes necessary hardener in the kit
- Provides a smooth, professional-grade base for painting
Cons
- Requires professional spray equipment with a 2.50mm-3.0mm nozzle
- Limited pot life once mixed with hardener
- Requires careful measurement of the hardening agent
- Not intended for large structural repairs
Setup, Compatibility & Care
To achieve the best results, your spray equipment must be properly configured. Use a spray gun with a nozzle size between 2.50mm and 3.0mm to accommodate the high-build viscosity of the filler. Always mix the filler and the provided 50ml hardener according to the specified mixing ratio to ensure proper cross-linking and curing. Store the unused product in a cool, dry place away from direct sunlight and moisture to maintain its chemical integrity. Always clean your spray equipment thoroughly with an appropriate gun cleaner immediately after use, as the product hardens chemically and can cause permanent damage to equipment if left to cure inside the nozzle.