Mitre Bond with Activator Pen - Unika - Multicolor
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone using the Unika MitreBond Adhesive with Activator Pen. It helps you understand how to use this rapid-setting adhesive system effectively, saving you time and ensuring strong bonds for various materials. Note that while the adhesive sets quickly, proper surface preparation is still crucial for optimal results.
All features
| Colour | Multicolor |
|---|---|
| Model Part Number | 5023778903965 |
| Brand | Unika |
Extended Product Information
FAQs
How long does it take for the adhesive to set?
The MitreBond adhesive sets in approximately 10 seconds when used with the activator pen.
What materials can I use this adhesive on?
It is suitable for use on cornice, profile mitre joints, melamine end strips, door trims, picture frames, MDF, and skirting joints.
How should I store the adhesive and activator pen?
Store them in a cool, dry place away from direct sunlight.
What should I do if the adhesive gets on my skin?
Do not pull the surfaces apart. Soak in warm, soapy water and gently peel the surfaces apart or gently roll off the skin.
Can I use this adhesive on plastics?
While the adhesive works on many materials, it's best to test on a small, inconspicuous area first to ensure compatibility with plastics.
How much activator is needed?
The pen provides the correct amount of activator and covers the same area as 3 x 200ml activator sprays.
What is the shelf life of the adhesive?
Shelf life can vary. Store properly and check for effectiveness before use.
Troubleshooting
Adhesive not bonding properly.
Ensure surfaces are clean and dry. Check that you are using enough adhesive and activator. Also, confirm the materials are compatible.
Adhesive drying too slowly.
Make sure the activator pen is working correctly. Replace if necessary. Ensure that both surfaces are being treated with the activator.
Adhesive dripping or running.
Apply a smaller amount of adhesive. Ensure the surfaces are level during the bonding process.
Pros and Cons
Pros
- Fast setting time, improving work efficiency.
- Suitable for various materials, increasing its versatility.
- High viscosity prevents dripping and ensures a cleaner application.
- Activator pen eliminates overspray for precise use.
- Provides strong and durable bonds.
- Environmentally friendly and non-hazardous formula.
Cons
- Requires careful alignment of materials due to the rapid setting time.
- Bond strength depends on proper surface preparation.
- May not be suitable for all types of plastics or materials.
- Shelf life may be limited once the activator pen is opened.
Setup, Compatibility & Care
- Preparation: Ensure surfaces are clean, dry, and free from dust or grease.
- Application: Apply a few drops of MitreBond to one surface, then spray or apply the activator from the pen to the other surface.
- Assembly: Immediately join the two surfaces and hold them together firmly for approximately 10 seconds.
- Compatibility: This adhesive is compatible with wood, MDF, melamine, and many other common building materials. Always test on a small, inconspicuous area first.
- Care: Store the adhesive and activator pen in a cool, dry place. Avoid direct sunlight. Clean up any spills immediately with a suitable solvent. Replace the pen cap after use to prevent drying.