Sheet Metal Punch - Q.Max - 10mm
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This 10mm Q.Max Sheet Metal Punch is designed for professionals and DIYers who need to create clean, precise metric-sized holes in sheet metal up to 16 gauge. Its key benefit is producing burr-free holes that require no additional finishing, saving time and effort. A caveat is that the punch is sold separately from the required 5mm hexagonal wrench.
All features
| Model Part Number | Qma-10M |
|---|---|
| Brand | Q.Max |
Extended Product Information
FAQs
What size hole does this punch create?
This specific model creates a 10.0mm diameter hole.
What thickness of sheet metal can this punch cut?
It is designed for sheet metal up to 16 gauge thickness.
Does the hexagonal wrench come with the punch?
No, the punch is sold separately from the required 5mm hexagonal wrench.
Do I need to finish the hole after cutting?
The special design produces a burr-free hole that typically needs no extra finishing.
How do I operate the punch for cutters 15mm and over?
The operating configuration differs for cutters 15mm and over; they often have fewer components and the thread is directly in the punch, eliminating the die nut. Refer to specific instructions for those sizes.
How should I maintain the punch to prevent rust?
After use, clean the punch and apply a light coat of oil to the cutting edges and threads. Store in a dry place.
What material is the punch made of?
The cutting edges are heat-treated for durability, and the tool features a black anti-corrosive surface finish.
Troubleshooting
Punch is difficult to turn or cut is incomplete.
Ensure the sheet metal is within the 16-gauge thickness limit. Verify the hexagonal screw is properly threaded into the punch and the die nut is securely seated against the metal. Check that the 5mm hexagonal wrench is engaging the screw fully.
Hole has rough edges or burrs.
While designed for burr-free cuts, extreme burring may indicate a dulling cutting edge. Clean the punch and die thoroughly. If the problem persists, the cutting edge may need replacement or sharpening (consult manufacturer guidelines).
Punch or die nut threads are sticking.
Clean the threads of both the punch and the die nut. Apply a small amount of lubricant or anti-seize compound to the threads before use. Ensure no metal debris is lodged in the threads.
Pros and Cons
Pros
- Produces clean, burr-free holes, saving finishing time.
- Designed for consistent performance with even load distribution.
- Durable, heat-treated cutting edges offer a long service life.
- Anti-corrosive finish helps maintain tool integrity.
- Metric sizing is ideal for specific applications.
Cons
- Requires a separate 5mm hexagonal wrench, which is not included.
- Limited to sheet metal up to 16 gauge thickness.
- Operating instructions differ for cutters 15mm and over.
- Punch and die nut must be ordered separately.
Setup, Compatibility & Care
Setup: To set up the Q.Max 10mm Sheet Metal Punch, first thread the punch onto the hexagonal screw. Then, pass this assembly through the pilot hole in your sheet metal. Place the die on the die nut and screw the die nut onto the exposed thread of the hexagonal screw until it firmly touches the metal surface. Ensure you have a 5mm hexagonal wrench ready for operation.
Compatibility: This punch is designed for use with sheet metal up to 16 gauge (approximately 1.5mm thickness). It is specifically for creating 10.0mm metric holes. Compatibility with the hexagonal screw and die nut system is standard for Q.Max punches up to 15mm.
Care: To maintain the performance and longevity of your punch, clean it after each use to remove metal shavings and debris. Apply a light coat of oil to the cutting edges and threaded components to prevent rust, especially during storage. Store the punch in a dry environment. The black anti-corrosive surface finish helps prevent rusting, but regular cleaning and occasional lubrication are recommended.