Today’s engines continually push the boundaries of technology and engineering. They are smaller and ultra-efficient, without sacrificing performance. Advanced engines challenge the oil with increased pressures. These intense pressures cause friction, which can waste up to 10% of an engine’s performance. Castrol EDGE with patented Fluid TITANIUM transforms its physical structure to be stronger under pressure to keep metal apart and reduces friction for maximum engine performance when you need it most. Castrol EDGE with Fluid TITANIUM: unlock the true performance of your engine. Application Castrol EDGE 5W-30 LL is suitable for use in automotive gasoline and diesel vehicles where the manufacturer recommends: ACEA C3 Castrol EDGE 5W-30 LL is approved by leading manufacturers. Please refer to your owners handbook. Castrol EDGE 5W-30 LL with Fluid TITANIUM is the natural choice for drivers who demand maximum engine performance from today’s modern vehicles requiring a high level of protection and higher performance oils. Transforms to be strongest when the pressure is highest, protecting your engine Reduces power-robbing friction across engine speeds and conditions Independently tested at the highest standards for proven performance Recommended by world-leading car manufacturers Protects the engine for the entire drain interval even under extreme pressure Specification ACEA C3 BMW Longlife-04 MB-Approval 229.31/ 229.51 Porsche C30 VW 504 00/ 507 00. The Castrol EDGE 1L 5W-30 LL Fully Synthetic Car Oil with Fluid Titanium physically transforms its structure becoming stiffer at points of extreme pressure, keeping metal apart and reducing friction. When the pressure subsides, the oil reverts to its free-flowing state. Stronger under pressure, it transforms its structure and reduces performance-robbing friction by 20%. Type: Fully Synthetic. Suitable for: ACEA C3, MB 229.31/229.51, VW 504 00/507 00, Porsche C30 and BMW LL-04. Storage: All packages should be stored under cover. Where outside storage is unavoidable drums should be laid horizontally to avoid the possible ingress of water and damage to drum markings. Products should not be stored above 60°C, or exposed to hot sun or freezing conditions.