Splashwall Panel Straight Joint - 2440mm - Gloss Silver Effect
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone installing Wetwall Alloy panels and needs a seamless, polished finish. The Splashwall Panel Straight Joint provides a clean and smooth connection between panels. However, remember to measure and cut the joint accurately for the best results.
All features
| Model Part Number | SWA-HSN-PS-2440 |
|---|---|
| Brand | Wetwall |
Extended Product Information
FAQs
What is the primary use of the Splashwall Panel Straight Joint?
The primary use is to join two Wetwall Alloy panels on a flat surface, creating a seamless and professional finish.
What material is the joint made from?
The joint is made from a material suitable for Wetwall Alloy panels and has a polished silver finish.
Can I use this joint with other panel brands?
No, this joint is specifically designed for use with Wetwall Alloy collection panels.
How do I cut the joint to the required size?
Use a fine-toothed saw to cut the joint. Measure carefully before cutting.
What kind of adhesive should I use?
Use a suitable adhesive recommended for Wetwall Alloy panels. Ensure the surfaces are clean before applying.
How do I clean the joint after installation?
Wipe clean with a damp cloth; avoid abrasive cleaners.
What is the length of the Splashwall Panel Straight Joint?
The joint is 2440mm in length.
Where can I use the Splashwall Panel Straight Joint?
You can use it in bathrooms, wet rooms, or any wall cladding project where you need to join two Wetwall Alloy panels on a flat surface.
Troubleshooting
Joint doesn't sit flush with panels.
Ensure the panels are correctly aligned and the joint is cut to the proper size. Check for any obstructions behind the panels.
Joint is difficult to cut.
Use a fine-toothed saw and apply slow, steady pressure when cutting. Consider using a lubricant designed for cutting metal.
Adhesive doesn't hold.
Make sure you're using a suitable adhesive for the panel material. Ensure both surfaces are clean and free of dust before applying the adhesive.
Pros and Cons
Pros
- Creates a seamless and professional finish.
- Easy to install and cut to size.
- Durable and long-lasting.
- Enhances the aesthetic of any room.
- Specifically designed for Wetwall Alloy panels
Cons
- Requires precise measurements for cutting.
- Only compatible with Wetwall Alloy panels.
- The polished silver finish may not match all design schemes.
- Needs careful handling to avoid scratches during installation.
Setup, Compatibility & Care
- Preparation: Ensure the Wetwall Alloy panels are installed and the wall surface is clean and prepared.
- Measurement: Measure the length needed for the joint, accounting for any gaps.
- Cutting: Use a fine-toothed saw to cut the joint to the required size.
- Installation: Apply a suitable adhesive to the back of the joint and carefully position it between the panels.
- Securing: Ensure the joint is flush with the panels and apply pressure for a few minutes to allow the adhesive to set.
*Compatibility: Only compatible with Wetwall Alloy collection panels.
*Care: Wipe clean with a damp cloth; avoid abrasive cleaners.