Kenable Ethernet Network Cable Boots - Black (100 Pack)
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for network installers and DIY enthusiasts looking to professionally finish and protect their custom-made Ethernet cables. The key benefit is enhanced cable durability and a clean, organized appearance for network installations. A potential caveat is their compatibility is limited to specific RJ45 connector types. These black Kenable boots protect the RJ45 connector and its retention clip, offering a professional finish and improved cable lifespan.
All features
| Model Part Number | 002350 |
|---|---|
| Brand | kenable |
Extended Product Information
FAQs
When should I put the boot on the cable?
The boot should be slid onto the network cable before you terminate the cable with an RJ45 connector.
Can these boots be used with Cat 6a or Cat 7 cables?
These boots are primarily designed for Cat 5, Cat 5e, and Cat 6. Compatibility with Cat 6a or Cat 7 may vary depending on the specific RJ45 connector used for those higher category cables.
How many boots come in a pack?
Each pack contains 100 Kenable Ethernet Network Cable Boots.
Can I add these boots to an existing cable?
No, these boots must be installed during the process of terminating the cable with an RJ45 connector. They cannot be added to a cable that has already been terminated.
What is the main purpose of these boots?
Their main purpose is to protect the RJ45 connector and its retention clip from damage, and to provide strain relief at the connection point, while also giving a professional finish to the cable.
Are these boots available in other colors?
This specific product is listed as black. Please check other listings for availability in different colors.
Troubleshooting
Boot does not fit over RJ45 connector
Ensure you are using a compatible RJ45 connector (standard Cat 5/5e/6) and that the boot was slid onto the cable before crimping the connector.
Boot does not cover the clip properly
Check that the boot is fully seated and covers the entire connector and clip. Ensure the boot is oriented correctly on the cable before crimping.
Boot feels loose after installation
This may indicate an incompatibility with the RJ45 connector. Try a different brand of connector, or ensure the cable jacket is properly seated within the boot.
Pros and Cons
Pros
- Protects delicate RJ45 connectors and clip from physical damage.
- Improves the overall aesthetic of custom-made network cables.
- Offers strain relief to prevent premature cable failure at the termination.
- Economical solution with a 100-pack providing good value.
- Easy to install during the termination process.
Cons
- May not fit oversized or non-standard RJ45 connectors.
- Requires installation during cable termination; cannot be added later.
- Color is fixed (black); limited aesthetic customization.
- Adds a slight amount of bulk to the cable termination end.
Setup, Compatibility & Care
Setup: These boots are designed to be slid onto the network cable *before* the RJ45 connector is crimped onto the wires. Once the connector is attached, the boot is then pulled forward to cover the connector and clip.
Compatibility: Compatible with standard RJ45 connectors used for Cat 5, Cat 5e, and Cat 6 Ethernet cables. They are not designed for non-standard or unusually sized connectors.
Care: As the boots are part of the cable termination, they do not require separate care. However, they are made from durable plastic and can be wiped with a dry or slightly damp cloth if they accumulate dust. Avoid harsh chemicals or solvents.