CleanShot Shut-Off Valve Airless Paint Sprayers - Tlily - 500758405
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Tlily CleanShot Shut-Off Valve is an essential accessory for professional painters and serious DIYers looking to enhance precision and reduce material waste during airless spraying projects. By providing an instantaneous shut-off at the tip, it eliminates the common issue of paint spitting or dripping, though users should ensure their existing extension poles are compatible with its 7/8-inch thread connection before purchase.
All features
| Model Part Number | 500758405 |
|---|---|
| Brand | Tlily |
Extended Product Information
FAQs
Will this valve fit my specific airless sprayer?
If your spray extension or gun uses a standard 7/8-inch thread, this valve will be compatible.
Can I use this with any type of paint?
Yes, it is designed for standard architectural coatings, but always ensure you flush it immediately after using heavy-bodied paints to prevent clogs.
What is the maximum pressure this valve can withstand?
The valve is rated for a maximum operating pressure of 3600 PSI.
Does it come with a spray tip?
No, this is the shut-off valve component only. You will need to attach your preferred airless spray tip to the end of the valve.
How do I ensure the swivel doesn't move during use?
The swivel is designed to be firm; if it is moving too freely, ensure the retaining nut is tightened properly, or adjust the tension per the manufacturer's guidance.
Troubleshooting
The valve is leaking at the connection point.
Ensure the thread is properly aligned and tightened, or replace the O-ring or gasket if it has become worn or flattened.
Paint continues to drip after the trigger is released.
The internal seal may have debris caught in it. Flush the valve thoroughly with solvent or disassemble and clean the internal needle assembly.
Swivel joint is stiff or hard to move.
Clear any dried paint residue from the swivel housing and apply a small amount of non-silicone lubricant to keep the movement smooth.
Pros and Cons
Pros
- Eliminates paint drips and spitting for a cleaner finish
- Highly maneuverable swivel head for complex angles
- Sturdy, industrial-grade construction for long life
- Compatible with a wide range of standard airless spray equipment
- Reduces total project time by limiting clean-up needs
Cons
- Requires specific 7/8-inch thread compatibility
- Adds slight weight to the end of the spray extension
- May require occasional seal maintenance if used with thick coatings
Setup, Compatibility & Care
To install, ensure your sprayer system is depressurized, then thread the valve onto your 7/8-inch tip extension. Tighten firmly with a wrench, but avoid over-torquing to prevent damage to the internal threads. The valve is compatible with most major airless paint sprayer systems that utilize the 7/8-inch connection standard. For maintenance, flush the valve thoroughly with the appropriate cleaning solvent (water or mineral spirits depending on the paint used) immediately after every job. Inspect the internal needle and seals periodically for wear, especially if you notice a decrease in shut-off crispness.