Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This Warren Reed - Designer splashback is for homeowners looking to add a touch of modern elegance and practical protection to their kitchen. Its key benefit is enhancing your kitchen's aesthetic while providing a durable, easy-to-clean surface. A caveat is the need for specific adhesive for installation. This premium 6mm toughened glass splashback features a high-resolution print of a polished pale pink quartz effect, offering a striking focal point that is both scratch-resistant and capable of withstanding heat.
| Model Part Number | WR01087-P450 |
|---|---|
| Brand | Warren Reed - Designer |
A clear, natural-curing adhesive is recommended. The manufacturer specifically recommends ColorSpray Splashback Adhesive and Sealant for optimal results.
No, this product is pre-sized and cannot be cut. Attempting to cut toughened glass can cause it to shatter.
Yes, the splashback is scratch and heat resistant up to 400°C, making it suitable for use behind most hobs, including gas.
Use a soft, damp cloth with a mild, non-abrasive kitchen cleaner. Wipe spills promptly. Avoid abrasive pads or harsh chemicals.
The product comes with a 1-year guarantee.
This specific model is W600mm x H600mm. Other sizes are available, including W600mm x H750mm, W700mm x H750mm, W900mm x H750mm, 600mm x H650mm, W700mm x H650mm, and W900mm x H650mm.
No, drilling into toughened glass is not possible and will cause it to break.
Ensure the wall surface is clean, dry, and perfectly flat. Use the recommended natural-curing adhesive and apply it evenly. Check that sufficient adhesive was used and that the splashback was held firmly in place during the initial curing period.
Avoid using abrasive cleaning tools or harsh chemicals. If minor scratches occur, they may be superficial on the protective coating. For deeper scratches, repair is not possible; replacement may be necessary.
Ensure cleaning is done with mild cleaners only. Avoid prolonged direct contact with harsh cleaning agents or solvents. If the issue persists, contact customer support.
Handle the glass with extreme care, especially around the edges. Ensure the wall surface is flat to avoid uneven pressure points. If damage occurs, do not install and contact the retailer for a replacement.
Setup: Ensure the wall surface where the splashback will be installed is clean, dry, and perfectly flat. Apply a clear, natural-curing adhesive generously and evenly to the back of the splashback or the wall, following the adhesive manufacturer's instructions. Carefully press the splashback into place, ensuring full contact and alignment. For best results, use ColorSpray Splashback Adhesive and Sealant. Allow adequate curing time before exposing to heat or moisture.
Compatibility: This splashback is designed for use behind hobs and cooktops, providing a protective barrier. It is compatible with most standard kitchen layouts and can be installed on most wall surfaces prepared with appropriate adhesive.
Care: Clean regularly with a soft, damp cloth and a mild, non-abrasive kitchen cleaner. Avoid using scouring pads, harsh chemicals, or abrasive cleaners, as these can damage the surface or the printed design. Wipe away spills immediately to prevent staining.
