Gorilla Epoxy Adhesive - Crystal Clear - 25ml - 5 Minute Set Time
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone looking to achieve strong, lasting bonds with Gorilla Epoxy. This adhesive is ideal for both household and automotive repairs, offering a permanent and durable solution. However, it's important to note that it's not recommended for use on polyethylene or polypropylene plastics.
All features
| Model Part Number | 6044001 |
|---|---|
| Brand | Gorilla Glue |
Extended Product Information
FAQs
How long does Gorilla Epoxy take to set?
Gorilla Epoxy sets in approximately 5 minutes.
What materials can I bond with Gorilla Epoxy?
Gorilla Epoxy bonds to steel, aluminum, glass, wood, ceramic, tile, and most plastics.
Can I use Gorilla Epoxy on polyethylene or polypropylene?
No, Gorilla Epoxy is not recommended for use on polyethylene or polypropylene plastics.
How should I store Gorilla Epoxy?
Store Gorilla Epoxy in a cool, dry place.
What is the bond strength of Gorilla Epoxy?
Gorilla Epoxy has a bond strength of 3300 PSI.
How do I clean up excess epoxy?
Clean up any excess epoxy immediately with a clean cloth or paper towel before it hardens.
How long does Gorilla Epoxy take to fully cure?
Full cure may take up to 24 hours.
Troubleshooting
Epoxy is not setting.
Ensure the resin and hardener were mixed thoroughly in equal parts. Check the expiration date. Ensure the ambient temperature is within the recommended range.
Bond is weak or fails.
Make sure surfaces were properly cleaned and prepared. Ensure the correct amount of epoxy was applied. Allow the epoxy to fully cure.
Epoxy is cloudy after drying.
Ensure the correct ratio of resin and hardener was used. Ensure the application was done in a dry environment.
Pros and Cons
Pros
- Fast setting time of 5 minutes.
- Bonds a wide variety of materials.
- Dries crystal clear for a clean finish.
- High bond strength (3300 PSI).
- Easy-to-use syringe for precise application.
Cons
- Not recommended for use on polyethylene or polypropylene plastics.
- Requires careful mixing of resin and hardener.
- May require surface preparation for optimal bonding.
- Limited working time due to fast setting.
- Potential for mess if not applied carefully.
Setup, Compatibility & Care
- Preparation: Clean the surfaces to be bonded. Ensure they are free from dust, grease, and oil for optimal adhesion. Lightly roughening the surfaces can also improve bonding.
- Dispensing: Use the syringe to dispense equal amounts of resin and hardener onto a clean surface.
- Mixing: Mix the resin and hardener thoroughly until the mixture is uniform in color.
- Application: Apply the mixed epoxy to one or both surfaces. Assemble the parts and hold them together for approximately 5 minutes until set.
- Curing: Allow the epoxy to fully cure according to the package instructions. Full cure may take up to 24 hours.
- Compatibility: Gorilla Epoxy is compatible with steel, aluminum, glass, wood, ceramic, tile, and most plastics. Avoid using it on polyethylene or polypropylene plastics.
- Care: Store the epoxy in a cool, dry place. Clean up any excess epoxy immediately with a clean cloth or paper towel before it hardens.