Tetrion Powerfil 2K 2 Part Body Filler - 2kg x 2 - TPW200
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Tetrion Powerfil 2K is an ideal solution for professionals and DIY enthusiasts who require a heavy-duty, versatile repair medium for wood, metal, stone, and plastic surfaces. It offers a distinct advantage in its ability to be drilled, screwed, and sanded once cured, providing a high-strength finish that hardens in minutes; however, users must work quickly due to the rapid 5-minute set time and ensure precise mixing ratios for optimal performance.
All features
| Model Part Number | TPW200 |
|---|---|
| Brand | Tetrion |
Extended Product Information
FAQs
Can I use this filler on plastic?
Yes, Tetrion Powerfil 2K is compatible with most plastics. We recommend performing a small test patch on an inconspicuous area first.
Do I need to prime before painting?
Yes, for the best finish, you should sand the cured filler until smooth and apply a suitable primer before painting.
How do I ensure the mixing ratio is correct?
Use a small plastic card or board to measure out a dollop of filler and a small, thin ribbon of hardener, adjusting until you achieve the 50:1 approximate volume ratio.
Is this product waterproof once cured?
Yes, it provides a hard, durable, and water-resistant finish once fully cured.
Can I store the mixed filler for later?
No. Once the hardener is mixed with the filler, the chemical reaction is irreversible and the product must be used immediately.
How thick can I apply the filler?
While it is designed for versatility, for very deep holes, it is best to apply in layers, allowing each to cure slightly before adding the next to ensure deep-set hardness.
Troubleshooting
The filler remains tacky after 20 minutes
This is likely due to an incorrect mixing ratio or insufficient mixing. Ensure you use the 1:50 ratio and mix until the color is completely uniform.
The mixture sets too quickly
Working in high temperatures can accelerate the cure time. Try mixing smaller batches at a time or work in a cooler environment.
Filler pulling away from the edges
The surface may have been greasy or damp. Ensure the substrate is cleaned with a degreaser and thoroughly dried before application.
Pros and Cons
Pros
- Extremely versatile across different surface types
- Can be drilled or screwed into once fully hardened
- Rapid setting time increases project efficiency
- Provides a smooth and durable professional finish
Cons
- Short 5-minute working window requires fast application
- Requires precise mixing ratios for proper curing
- Not suitable for use in unventilated areas
Setup, Compatibility & Care
To ensure maximum durability, follow these steps for application:
- Surface Preparation: Ensure the surface is completely clean, dry, and free from grease or loose debris.
- Mixing: Use a ratio of 1 part hardener to 50 parts filler. Mix thoroughly on a clean board until the color is consistent throughout.
- Application: Apply the mixture using the included spreader, working it into the repair area with firm pressure to avoid air pockets.
- Curing: Allow the product to sit for approximately 20 minutes at room temperature before sanding or shaping.
- Safety: Always work in a well-ventilated area and avoid contact with skin and eyes. Store the components in a cool, dry place to maintain shelf life.