TIMCO PE Polyester General Purpose Anchor Resin - 410ml - PE410
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The TIMCO PE Polyester General Purpose Anchor Resin (PE410) is designed for contractors and DIY enthusiasts who need a reliable fixing solution for both solid and hollow masonry. Its key benefit is the high-performance, low-odour formula that works efficiently in enclosed spaces, though users should note it is strictly for non-safety critical applications.
All features
| Model Part Number | PE410 |
|---|---|
| Brand | TIMCO |
Extended Product Information
FAQs
Is this resin suitable for structural load-bearing projects?
No, this product is specifically for non-safety critical fixing applications.
Can I use this with a standard silicone sealant gun?
No, you must use an applicator gun specifically designed for 410ml side-by-side resin cartridges.
Does the resin come with a nozzle?
Yes, the product includes a mixing nozzle for immediate use.
Is the resin safe to use indoors?
Yes, it features a low-odour formula suitable for poorly ventilated environments.
How do I handle hollow masonry?
You must use a mesh sleeve to ensure the resin remains in place and forms a proper anchor.
Can this be used for overhead installations?
While it is versatile, ensure the hole is properly cleaned and the resin is fully supported during the curing process.
Troubleshooting
Resin is not curing properly
Ensure the surface is dry and free of oil or dust; check the shelf life of the cartridge.
Resin colour is streaky after mixing
Discard the first few pumps of the nozzle until the output colour is uniform.
Difficulty extruding the resin
Check if the nozzle is blocked or if the ambient temperature is too low; warm the cartridge slightly if cold.
Pros and Cons
Pros
- Efficient mixing system reduces waste
- Suitable for indoor use due to low odour
- Easy to dispense with minimal extrusion force
- Fire-rated for added security
- Ideal for a wide range of general-purpose tasks
Cons
- Not intended for safety-critical structural loads
- Requires a compatible 410ml resin applicator gun
- Solid and hollow materials require different preparation methods
Setup, Compatibility & Care
To begin, ensure you have a standard 410ml resin applicator gun. Before application, the hole must be completely free of dust and debris for the bond to set correctly. Once the nozzle is attached, dispense the first few millimetres of resin onto a scrap surface until you see a uniform colour; this ensures the two components are mixed properly. Store the cartridge in a cool, dry environment away from direct sunlight, and always replace the cap or use a fresh nozzle if the resin will be stored for later use.