Murrelektronik Sensor/Actuator Connector - 7000-08331-0000000
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Murrelektronik 7000-08331-0000000 is a professional-grade M8 male connector designed for industrial automation technicians and electrical engineers who require reliable, field-wireable solutions for sensor and actuator integration. It features a space-saving straight design and utilizes advanced IDC termination technology to provide secure signal transmission in demanding environments, though it requires precise cable preparation to ensure a proper connection.
All features
| Model Part Number | 7000-08331-0000000 |
|---|---|
| Brand | Murrelektronik |
Extended Product Information
FAQs
What wire size does this connector support?
This connector is compatible with wire cross-sections between 0.14 mm² and 0.34 mm².
Do I need special tools for this connector?
No, the IDC (Insulation Displacement Contact) technology allows for termination without specialized crimping tools.
Is this a shielded connector?
This model is an unshielded M8 connector intended for standard signal transmission.
Can I reuse this connector if I remove the cable?
While technically possible, it is generally recommended to use a new connector after removal to ensure the integrity of the IDC connection.
Is this connector compatible with M12 ports?
No, this is an M8 connector and will not physically fit into an M12 port.
What is the pole count for this model?
This model is a 3-pole (3-pin) configuration.
Troubleshooting
Intermittent signal transmission
Verify that the wire gauge is within the 0.14-0.34 mm² range and ensure the connector cap is fully seated and tightened.
Difficulty inserting wires into IDC terminals
Check if the wires are bent or if the insulation is too thick; ensure wires are cut cleanly at the end to allow for smooth entry.
Physical housing damage
If the plastic housing is cracked during installation, the connector must be replaced to maintain the ingress protection rating.
Pros and Cons
Pros
- Efficient IDC termination saves installation time
- Compact 3-pole M8 design fits tight industrial cabinets
- High-quality construction ensures reliable signal integrity
- No soldering or specialized crimping tools required
Cons
- Strict requirement for wire diameter compatibility
- Requires careful manual assembly to ensure proper IDC contact
- Not suitable for high-vibration environments without proper cable strain relief
Setup, Compatibility & Care
To install this connector, ensure your cable jacket is clean and compatible with the 0.14 to 0.34 mm² wire range. Insert the unstripped wires into the designated internal terminals and tighten the connector cap securely until the IDC pins have fully pierced the insulation. Always inspect the connection for alignment before final tightening. Store unused connectors in a dry, dust-free environment to prevent oxidation of the internal metal contacts, and avoid excessive force during installation to prevent deformation of the plastic housing.