Knipex VDE 1000V Self-Clamping Slip-On Cap - 110 mm - 98 66 30
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Knipex VDE 1000V Self-Clamping Slip-On Cap is an essential safety accessory designed for professional electricians and technicians who perform live electrical work. Its primary benefit is providing reliable protection against exposed conductors that have been stripped of insulation, preventing accidental short-circuits or contact. While it offers excellent insulating properties, users must note that this specific model is sized for a 30 mm diameter, meaning it will not fit conductors significantly larger or smaller than that specification.
All features
| Model Part Number | 98 66 30 |
|---|---|
| Brand | KNIPEX |
Extended Product Information
FAQs
Is this cap safe for use on 1000V systems?
Yes, this product is VDE rated for work up to 1000V, provided it is used in accordance with standard safety practices.
Can I use this on conductors smaller than 30 mm?
It is not recommended. The self-clamping feature relies on the 30 mm diameter to create the necessary friction and tension to stay attached.
Is the material conductive?
No, it is made from specialized non-conductive insulating material designed specifically for electrical safety.
How do I know if the cap is damaged?
Inspect for visible cracks, melted areas, or any loss of tension in the clamping mechanism. If any damage is found, replace the cap immediately.
Can this be reused?
Yes, it is designed for repeated use, provided it remains in good condition and continues to fit the conductor securely.
Troubleshooting
Cap keeps sliding off the conductor
Verify the conductor diameter is truly 30 mm. If the conductor is too thin, the clamping mechanism cannot maintain adequate pressure.
Difficulty installing the cap
Ensure the wire end is straight and free of sharp burrs that might catch on the inner lining of the cap.
Pros and Cons
Pros
- Certified for 1000V live electrical work
- Secure self-clamping mechanism prevents accidental slipping
- Robust construction for repeated industrial use
- High-visibility design for job site safety
Cons
- Limited to a 30 mm conductor diameter
- Requires proper sizing for effective installation
- Not intended for use on energized cables with compromised structural integrity
Setup, Compatibility & Care
To install, simply align the cap with the conductor and press firmly until the self-clamping mechanism engages. Before use, verify that your conductor diameter is approximately 30 mm to ensure a snug, safe fit.
Care Instructions:
- Periodically inspect the cap for cracks, tears, or signs of material degradation.
- Clean with a dry or slightly damp cloth; avoid harsh solvents that could compromise the insulating properties of the plastic.
- Store in a cool, dry place away from direct sunlight or extreme heat to prevent material fatigue.