Warren Reed - Designer Chilling In The Branches Glass Bathroom Splashback - WR01511-P464
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This Warren Reed glass splashback is ideal for homeowners seeking an elegant and low-maintenance upgrade for their bathroom basin area. Its key benefit is providing a sophisticated, hygienic surface that is resistant to moisture, mould, and stains, eliminating the need for grout. A potential caveat is its specific design for behind basins, which may limit its application elsewhere.
All features
| Model Part Number | WR01511-P464 |
|---|---|
| Brand | Warren Reed - Designer |
Extended Product Information
FAQs
What material is the splashback made from?
It is made from 6mm toughened safety glass.
Is this splashback suitable for a shower area?
This splashback is designed for bathroom basin areas and is resistant to moisture. However, it is not typically intended for direct, prolonged exposure to shower spray.
How do I clean the splashback?
Clean it with a soft, damp cloth and warm, soapy water. Avoid abrasive cleaners.
Does it require drilling into the wall?
No, the splashback is designed for adhesive installation and does not require drilling.
What are the dimensions of this splashback?
The dimensions are W600mm x H250mm.
Is the design prone to fading?
The print is high-quality and designed for durability in a bathroom environment. Fading is unlikely under normal conditions and with proper care.
Can I install this myself?
Yes, the splashback is designed for easy DIY installation with clear instructions provided. Ensure you follow the adhesive and curing instructions carefully.
Troubleshooting
Splashback not adhering properly
Ensure the wall surface was clean, dry, and properly prepared. Verify that the correct type and amount of adhesive were used and that it was allowed to cure fully before use.
Surface appears cloudy or streaky after cleaning
You may be using too much cleaning solution or an abrasive cleaner. Try cleaning with a damp microfiber cloth and plain water, then buff dry with a separate clean, dry microfiber cloth.
Small chip or scratch on the glass surface
Unfortunately, chips or deep scratches on toughened glass cannot be repaired. Inspect carefully before installation and contact the manufacturer if damage is present upon arrival.
Pros and Cons
Pros
- Significantly enhances bathroom aesthetics with a designer print.
- Highly resistant to common bathroom issues like moisture and mould.
- Eliminates grout lines, making cleaning and maintenance much simpler.
- Durable construction from toughened safety glass.
- Straightforward installation process without requiring special tools or drilling.
Cons
- Primarily designed for installation behind basins, limiting placement options.
- Requires careful handling during installation due to its glass nature.
- May be more expensive than traditional tile solutions.
- The specific design pattern might not suit all bathroom decors.
- If damaged, it requires replacement rather than repair.
Setup, Compatibility & Care Instructions
Setup:
- Ensure the wall area behind the basin is clean, dry, and free from any loose paint or debris.
- Read the provided installation instructions carefully before beginning.
- Apply the recommended adhesive (often a silicone sealant, check product manual for specifics) to the back of the splashback or the wall as directed.
- Carefully position the splashback onto the wall behind the basin, ensuring it is level and aligned correctly.
- Press firmly to secure the splashback. Clean any excess adhesive immediately.
- Allow the adhesive to cure fully according to the manufacturer's recommendations before using the basin.
Compatibility:
- Designed to fit behind most standard bathroom basins.
- Suitable for installation on plasterboard, tiles, or painted walls (ensure wall surface is sound and prepared).
- Not intended for use in high-heat areas like behind ovens or cooktops.
Care:
- Clean regularly using a soft, damp cloth with warm, soapy water.
- Avoid abrasive cleaners, scouring pads, or harsh chemicals, as these can damage the printed surface or glass.
- Dry with a clean, soft cloth after cleaning to prevent water spots.