Soudal Genius Gun Plasterboard Adhesive Foam - Beige - 750ml
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone looking for a quick and easy way to bond plasterboard and other building materials. The Soudal Genius Gun Plasterboard Adhesive Foam offers a fast-curing, one-handed operation solution, replacing traditional mortar. However, it's essential to ensure proper surface preparation for optimal adhesion.
All features
| Colour | Beige |
|---|---|
| Brand | Soudal |
Extended Product Information
FAQs
What materials can I bond with this foam?
The Soudal Genius Gun Plasterboard Adhesive Foam is suitable for bonding plasterboard, wood, metal, MDF, insulation board, and many other common building materials.
How long does it take for the foam to cure?
The curing time depends on environmental conditions such as temperature and humidity, but it generally cures quickly. Refer to the product label for specific curing times.
Can I use this foam outdoors?
Yes, this adhesive foam is suitable for both interior and exterior use.
How do I clean the Genius Gun applicator?
Use Soudal Gun Cleaner to clean the applicator after each use. Remove the can and flush the applicator with the cleaner.
How long can I reuse a partially used can?
The foam can be reused for up to six weeks between applications, provided the nozzle is properly sealed and cleaned.
What is the shelf life of the foam?
The shelf life is typically 12 months when stored in a cool, dry place.
Is the foam waterproof?
The foam is water-resistant, but it is not intended for continuous submersion in water.
Does it work with all types of plasterboard?
Yes, it is compatible with standard plasterboard panels.
Troubleshooting
Foam does not dispense.
Check if the can is properly attached to the Genius Gun applicator. Ensure the nozzle is not blocked. Clean the nozzle with Soudal Gun Cleaner.
Poor adhesion.
Ensure surfaces are clean and dry. Apply sufficient foam in the recommended pattern. Provide adequate pressure during bonding.
Excessive foam expansion.
Apply the foam sparingly. Avoid over-application. Use temporary supports if necessary to prevent movement during curing.
Pros and Cons
Pros
- Saves time compared to traditional mortar methods.
- Easy to use with the Genius Gun trigger.
- Suitable for a wide range of building materials.
- Reusable for multiple applications.
Cons
- Requires the purchase of a Genius Gun applicator.
- Surface preparation is crucial for optimal adhesion.
- May require more product for uneven surfaces compared to traditional methods.
- Foam can expand, requiring careful application to avoid excess material.
Setup, Compatibility & Care
- Preparation: Ensure surfaces are clean, dry, and free from dust, grease, and loose particles. For porous surfaces, consider priming.
- Application: Attach the can of foam to the Soudal Genius Gun applicator. Apply the foam in vertical beads, approximately 30cm apart.
- Placement: Immediately position the plasterboard or other material onto the foam beads.
- Pressing: Apply firm and even pressure for a few minutes to ensure proper adhesion. Use temporary supports if necessary, especially for heavier materials.
- Curing: Allow the foam to cure completely before applying any significant load or finishing.
- Compatibility: The foam is compatible with a wide range of building materials, including masonry, timber, plasterboard, wood, metal, and many others. It is not recommended for use with certain plastics that are not specifically compatible with polyurethane products.
- Care: Store the foam cans in a cool, dry place. After use, clean the Genius Gun applicator to prevent the foam from curing and blocking the nozzle. Use Soudal Gun Cleaner for best results. Protect from direct sunlight.