Integral LED Evofire Fire Rated Downlight - Silver
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone installing or using the Integral LED Evofire Downlight. Its key benefit is its fire-rated design and can-less construction, promoting efficient airflow and extending the life of LED lamps. Note that lamps are not included and must be purchased separately.
All features
| Colour | Silver |
|---|---|
| Model Part Number | 69071 |
| Brand | Integral LED |
Extended Product Information
FAQs
What type of lamps can I use?
You must use LED GU10 lamps with a maximum wattage of 10W.
Are the lamps included?
No, the lamps are not included and need to be purchased separately.
What is the cut-out size required?
The cut-out size should be between 70mm and 100mm.
What is the fire rating?
The downlight has a 30/60/90 minute fire rating.
How do I install the downlight?
Follow the installation steps outlined in the 'Setup' section of this guide.
Can I use dimmable lamps?
Yes, provided the lamp is compatible with dimming and the appropriate dimmer switch is used.
What is the depth of the downlight?
The depth of the downlight is 38mm.
Troubleshooting
Downlight doesn't turn on.
Check the lamp to ensure it is correctly installed and functioning. Verify the power connection and the circuit breaker.
Lamp flickers.
Check the lamp and replace it if necessary. Ensure the lamp is compatible with the downlight.
Downlight is not flush with the ceiling.
Check the cut-out size, ensuring it's within the 70-100mm range. Make sure the downlight is properly seated.
Pros and Cons
Pros
- Fire-rated design for enhanced safety.
- Can-less design improves airflow and lamp life.
- Easy to install with screwless terminals.
- Compatible with a wide range of cut-out sizes.
- Sleek and modern aesthetic.
Cons
- Lamps are not included and must be purchased separately.
- Only compatible with LED GU10 lamps.
- Requires a 70-100mm cut-out for installation.
Setup, Compatibility & Care
Setup:
- Ensure the power is switched off before installation.
- Prepare the 70-100mm cut-out in the ceiling.
- Connect the wires to the screwless push-fit terminals.
- Insert the downlight into the cut-out.
- Install the LED GU10 lamp (max 10W).
Compatibility:
- Compatible with LED GU10 lamps only.
- Suitable for cut-out sizes between 70mm and 100mm.
- Compatible with the Integral Classic GU10 Lamp (4W, Warm White, 345lm, 10 pack, code 69071).
Care:
- Clean the downlight with a soft, dry cloth.
- Do not use harsh chemicals or abrasive cleaners.
- Regularly inspect the downlight for any signs of damage.