Wallsupply Polymer Grab Adhesive Glue - Black - Pack of 3
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Wallsupply Polymer Grab Adhesive is designed for DIY enthusiasts and interior professionals looking to securely mount 3D wall panels, particularly the Rebel of Styles range. Its primary benefit is a high-strength, moisture-resistant bond that works across diverse surfaces including masonry, wood, and PVC, though users should note that drying times can vary based on ambient humidity and surface porosity.
All features
| Colour | Black |
|---|---|
| Model Part Number | 45110002-3 |
| Brand | Wallsupply |
Extended Product Information
FAQs
Does this glue work on painted walls?
Yes, provided the paint is stable and not peeling. It is recommended to sand glossy paint to improve adhesion.
How many cartridges do I need for a 5 square meter wall?
Since one cartridge covers approximately 1.5 to 2 square meters, you will need 3 to 4 cartridges for a 5 square meter project.
Is this adhesive waterproof?
It is moisture-resistant, making it suitable for standard indoor environments, though it is not intended for direct, prolonged submersion in water.
Can I use this for ceiling installations?
It is designed for wall panels; for ceiling applications, ensure you use adequate temporary support until the glue has fully cured.
How long does it take to fully cure?
While it has a quick initial grab, a full cure typically takes 24-48 hours depending on the temperature and humidity.
Troubleshooting
Adhesive is difficult to squeeze out of the cartridge
Ensure the nozzle tip is cut at a 45-degree angle and check that the internal foil seal has been fully punctured.
Panels are sliding after placement
You may have applied too much adhesive or the substrate is non-porous; use temporary painter's tape to hold the panels in place until the initial set occurs.
Weak bond on dusty wall surface
Remove all dust and loose debris from the wall with a stiff brush or vacuum before re-applying the adhesive.
Pros and Cons
Pros
- High-strength bonding for heavy 3D panels
- Works on both mineral and organic surfaces
- Solvent-free formula is safer to use indoors
- Convenient multi-pack for standard projects
Cons
- Not suitable for non-standard wall panel materials
- Requires a caulking gun for application
- Limited coverage per cartridge for very large installations
Setup, Compatibility & Care
To begin installation, ensure you have a standard caulking gun to dispense the adhesive from the 290ml cartridges. Prepare your wall surface by removing any loose paint, wallpaper, or grease to ensure a clean bonding area. For best results, apply the adhesive in vertical beads. If the adhesive contacts your skin or tools, clean it immediately with a damp cloth before it cures. Store unused cartridges in a cool, dry place and ensure the nozzle is sealed tightly to prevent the polymer from hardening inside the tube.