GoPro Universal Adhesive Mount - 2-Pack
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The GoPro Universal Adhesive Mount 2-Pack is an essential accessory for action enthusiasts and content creators who need reliable, secure camera placement on smooth surfaces. Designed for versatility, this pack allows you to expand your shooting angles by mounting your GoPro to helmets, drones, vehicles, or sports gear. While the industrial-strength adhesive provides a rock-solid bond for demanding environments, users should note that the mounts are intended for single-use application and require a clean, dry surface to ensure a proper seal.
All features
| Brand | GoPro |
|---|
Extended Product Information
FAQs
Can I reuse these mounts after removing them?
No, the adhesive is designed for a one-time application. Once removed, you will need to apply a fresh adhesive strip to use the mount again.
Will these damage my helmet or vehicle paint?
When removed properly using heat, the mounts should not damage factory paint or standard helmet finishes. Always test on an inconspicuous area if you are concerned.
Can I use these on textured plastic surfaces?
These mounts are designed for smooth surfaces. They may not achieve a full seal on highly textured or porous materials.
Are they safe for high-speed applications?
Yes, when applied correctly to a clean, smooth surface, these mounts are engineered to withstand the wind resistance and vibrations associated with high-speed action.
What is the best way to remove the mount?
Use a hair dryer or heat gun on a low setting to warm the base. This softens the adhesive, allowing you to gently pull the mount off without pulling up the surface finish.
Troubleshooting
Mount falls off during use
The surface was likely not cleaned thoroughly enough or the adhesive did not cure for the required 24 hours. Ensure the surface is completely oil-free before applying a new mount.
Adhesive residue remains on the surface after removal
Use a citrus-based adhesive remover or a soft cloth dampened with rubbing alcohol to gently work away any remaining sticky residue.
Pros and Cons
Pros
- Extremely strong, weather-resistant bond
- Works on a variety of smooth surfaces including plastic, metal, and glass
- Compact and lightweight footprint
- Compatible with the standard GoPro ecosystem of accessories
Cons
- Not intended for reuse once removed
- Requires specific surface preparation to achieve maximum bond strength
- Not suitable for textured or porous surfaces
Setup, Compatibility & Care
To ensure a long-lasting bond, follow these steps for installation:
- Clean the Surface: Use an isopropyl alcohol pad to wipe down the target area. Remove all dust, grease, or wax so the adhesive can bond directly to the surface material.
- Apply at Room Temperature: Avoid applying the mount in extremely cold conditions. Ideal application temperature is between 70°F and 100°F (21°C to 38°C).
- Allow to Cure: Once applied, press down firmly across the entire base. Wait at least 24 hours to ensure the chemical bond is fully set before use.
- Removal: If you need to remove the mount, use a heat gun or hair dryer to warm the adhesive. The heat softens the glue, allowing you to peel it away from the surface without damaging the substrate.