Tamiya Spray Paint TS-79 Semi Gloss Clear - 100ml
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Tamiya Spray Paint TS-79 Semi Gloss Clear in a 100ml can is designed for model enthusiasts seeking a professional, smooth finish on their plastic models. Its key benefit is providing a high-quality synthetic lacquer clear coat that dries quickly and offers excellent coverage for achieving realistic results. A potential caveat is the necessity of using a primer for optimal adhesion.
All features
| Model Part Number | TS-79 |
|---|---|
| Brand | Tamiya |
Extended Product Information
FAQs
What is the best way to prepare my model before using TS-79?
It is highly recommended to clean your model thoroughly and apply a suitable primer. This ensures better adhesion and a more even finish for the clear coat.
Can I use this spray paint on materials other than plastic models?
Tamiya TS spray paints are specifically formulated for plastic model kits. Compatibility with other materials may vary and is not guaranteed.
How long does the paint take to dry?
Tamiya TS paints are known for their quick-drying properties. However, drying times can vary based on humidity, temperature, and application thickness. It's best to allow sufficient time for recoating or handling.
How do I clean the spray nozzle after use?
After painting, turn the can upside down and spray for a few seconds until only clear propellant comes out. This prevents the nozzle from clogging.
What is the coverage of a 100ml can?
A 100ml can is typically sufficient to cover two to three 1/24 scale car bodies.
Can I apply acrylic or enamel paints over this clear coat?
Yes, Tamiya TS sprays are compatible with acrylic and enamel paints, allowing for further detailing and finishing.
Is this paint glossy or matte?
This specific product, TS-79, provides a semi-gloss finish.
Troubleshooting
Uneven spray pattern or clogging
Shake the can more vigorously. Clean the nozzle thoroughly by spraying upside down with clear propellant. If persistent, try a new nozzle or can.
Paint not adhering well
Ensure the surface was properly cleaned and primed before application. Check that the surface is dry and free from contaminants.
Runs or drips
The paint was likely applied too thickly or too close to the model. Apply in lighter coats from a slightly greater distance.
Surface appears dull or patchy
Ensure even coverage with consistent spray distance and speed. Check if the can was shaken sufficiently before and during use.
Pros and Cons
Pros
- Provides a professional semi-gloss finish.
- Quick drying time saves project time.
- Good coverage for its size.
- Compatible with other Tamiya paints and primers.
- Specifically designed for model painting.
Cons
- Requires a primer for best results.
- Synthetic lacquer may require specific ventilation.
- 100ml may be insufficient for very large models.
- Not suitable for all material types beyond plastic models.
Setup, Compatibility & Care
Setup:
- Ensure the model or parts are clean and free from dust or grease.
- Apply a suitable primer (recommended for best adhesion).
- Shake the can vigorously for at least one minute before use.
- Hold the can upright approximately 25-30 cm away from the surface.
- Apply in light, even strokes, overlapping each pass slightly.
- Allow adequate drying time between coats.
Compatibility:
- Compatible with Tamiya acrylic and enamel paints.
- Best applied over a Tamiya primer or a suitable model primer.
- Designed for use on plastic model kits.
Care:
- Store in a cool, dry place away from direct sunlight and heat.
- Keep the nozzle clean after each use by turning the can upside down and spraying for a few seconds until clear propellant emerges.
- Clean any accidental spills immediately with appropriate solvent (refer to Tamiya's guidelines or product packaging for specific solvent recommendations).