10PCS 40P 2.54mm Spacing Single Row Right Angle Male Pin Header Strip - FIPUX
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The FIPUX 40P Right Angle Male Pin Header Strip is an essential component for electronics hobbyists, engineers, and DIY enthusiasts working on PCB assembly, breadboarding, and custom computer hardware projects. These 10-piece sets provide a reliable, space-saving interface for routing connections at a 90-degree angle, though users should be prepared to snap or cut the strips to the exact pin count required for their specific circuits.
All features
| Model Part Number | DOESNOTAPPLY |
|---|---|
| Brand | FIPUX |
Extended Product Information
FAQs
Can I use these on a standard breadboard?
Yes, the 2.54mm pitch is the standard spacing for all breadboards and perfboards.
How do I cut these to a specific length?
Use sharp wire cutters or flush cutters to snip the plastic strip between the pins at the desired position.
Are these pins magnetic?
Most standard header pins are made from copper alloy or steel; it is recommended to use them for signal and low-power applications.
Can these be used for high-voltage applications?
No, these headers are designed for low-voltage electronic signals, typically under 24V.
Does this set include female headers?
No, this set consists exclusively of male right-angle pin headers.
What is the material of the plastic housing?
The housing is made from heat-resistant thermoplastic, designed to withstand standard soldering temperatures.
Troubleshooting
Pin header is too long for the project
Use a pair of side cutters or flush cutters to trim the strip between the pins to your desired length.
Poor connection or intermittent signal
Check for cold solder joints at the PCB interface and ensure the header is sitting flush against the board.
Pros and Cons
Pros
- Standard spacing fits almost all hobbyist electronics modules
- Right angle orientation is ideal for low-profile project boxes
- Easy to snap off sections to get the exact pin count needed
- Sturdy housing prevents pin bending during insertion
Cons
- Requires soldering for permanent PCB installation
- Requires precision cutting for non-standard pin counts
- Not intended for high-current power distribution applications
Setup, Compatibility & Care
To install these headers, align the pin side with the through-holes on your PCB. Use a soldering iron to bond each pin to the copper pads, ensuring you do not leave the iron on the pin for too long to avoid melting the plastic insulation.
- Compatibility: These pins are fully compatible with standard 2.54mm (0.1") female jumper wires and standard breadboard sockets.
- Care: Keep the pins dry and avoid excessive bending. If a pin becomes oxidized over years of storage, a light cleaning with isopropyl alcohol or a gentle rub with a fine eraser will restore connectivity.