OB1 Multi-Surface Grip & Grab Adhesive - 290ml (3 Pack)
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This OB1 Multi-Surface Grip & Grab Adhesive is designed for trade professionals and DIYers needing a strong, fast bond for interior and exterior applications. Its key benefit is the high-strength, instant grab formula that reduces the need for temporary support. A potential caveat is the 290ml cartridge size, which may require multiple tubes for very large projects. This adhesive offers reliable, weatherproof bonding for a wide range of surfaces, making installation, fitting, and repair tasks more efficient.
All features
| Brand | OB1 |
|---|
Extended Product Information
FAQs
Can this adhesive be used for structural bonding?
While OB1 Grip & Grab Adhesive provides high strength and immediate hold, it is primarily designed for fitting, installation, and repair tasks rather than primary structural load-bearing applications. Always consult relevant building codes and engineering specifications for structural elements.
How long does it take to fully cure?
Full cure times vary depending on temperature, humidity, and bead size, but typically range from 24 to 48 hours. Initial grab is achieved within minutes.
Is this adhesive paintable?
Once fully cured, the adhesive can typically be painted over. It is recommended to test compatibility with your chosen paint on a small area first.
What surfaces is this adhesive NOT suitable for?
Avoid use on certain types of polyethylene, polypropylene, PTFE, or silicone. Always test on a small area first.
Do I need a special gun for this cartridge?
No, this 290ml cartridge is designed to fit standard skeleton-style adhesive dispenser guns.
Can it be used underwater?
The weatherproof formula is designed for exterior use, but not for continuous submersion in water. It should not be used for underwater applications.
How should I store unused cartridges?
Seal the nozzle tightly and store in a cool, dry place. For best results, try to use opened cartridges within a reasonable timeframe.
Troubleshooting
Adhesive not dispensing
Ensure the cartridge is properly loaded in the dispenser gun and the internal seal has been punctured. Check that the nozzle is not blocked.
Weak initial bond
Verify that surfaces are clean, dry, and free from dust, grease, or loose material. Ensure adequate pressure was applied during bonding.
Adhesive is too slow to cure
Ensure adequate ventilation. Check ambient temperature and humidity, as extreme conditions can affect curing times.
Discoloration on surface
Test on a small, hidden area first. Some plastics or painted surfaces may react with the adhesive; use a compatible sealant or primer if necessary.
Pros and Cons
Pros
- Provides a very strong initial grab for quick assembly.
- Suitable for a wide array of indoor and outdoor projects.
- Weatherproof formula enhances durability in exposed conditions.
- Multi-surface capability simplifies material selection.
- Controlled application from the 290ml cartridge.
Cons
- May require multiple cartridges for very large surface areas.
- Application requires a suitable adhesive dispenser gun (not included).
- Requires adequate ventilation during application and curing.
- Bond strength may vary slightly depending on surface preparation.
Setup, Compatibility & Care Instructions
Setup:
- Ensure you have a standard adhesive dispenser gun.
- Cut the nozzle tip to the desired bead size.
- Puncture the internal seal of the cartridge.
- Load the cartridge into the dispenser gun and apply steady pressure to extrude the adhesive.
Compatibility:
Suitable for bonding wood, metal, brick, concrete, plaster, most plastics, and more. Always test on a small, inconspicuous area first, especially on sensitive surfaces or plastics.
Care:
- Store cartridges in a cool, dry place, away from direct sunlight and frost.
- Ensure the nozzle is sealed after use to prevent curing within the cartridge.
- Clean up any excess uncured adhesive immediately with a damp cloth or appropriate solvent. Cured adhesive may require mechanical removal.