Jenolite Luminous Glow In The Dark Paint - 400Ml Spray Can

Currently unavailable

Currently unavailable
This guide helps users of Jenolite Luminous Glow in the Dark Paint understand its application and benefits. Ideal for artists, DIY enthusiasts, and anyone looking to add a luminous effect to their projects, this paint stores light and emits a glow in darkness. However, it's important to note that the intensity and duration of the glow depend on the light exposure it receives. This guide covers key features, usage instructions, and troubleshooting tips to ensure you achieve the best results with your Jenolite paint.
| Brand | JENOLITE |
|---|
The glow duration depends on the light exposure it receives. Generally, it will glow for several hours after being charged.
While the paint is primarily designed for hard surfaces, it may be used on fabric, but results may vary. Test on a small area first.
For optimal results, apply multiple thin coats. The exact number will depend on the surface and desired effect, but 2-3 coats are generally recommended.
The paint offers some water resistance, but it's not fully waterproof. Avoid prolonged exposure to water.
Remove the nozzle and soak it in a solvent like paint thinner. Then, clean the nozzle before reattaching it to the can.
Coverage depends on the application method and surface, but a 400ml spray can typically covers a few square meters, depending on the number of coats applied.
Dispose of the empty can according to local regulations for aerosol cans. Check with your local waste management services for specific instructions.
Ensure the painted surface is exposed to bright light for an adequate amount of time. Apply additional coats of paint or try a different light source for charging.
Clean the surface thoroughly before application. Ensure the surface is free of any contaminants and apply the paint in thin, even coats.
Shake the can well before use. Hold the spray can at the correct distance from the surface and apply thin, even coats. Avoid applying too much paint in one go.
Clean the nozzle immediately after use. If the nozzle is clogged, remove it and soak it in a suitable solvent before reattaching it.