Weld-On 725 Wet R Dry PVC Pipe Solvent Cement - WETRDRY240
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
Weld-On 725 Wet R Dry Solvent Cement is designed for professional plumbers, irrigation specialists, and DIY enthusiasts who need to complete PVC pipe repairs in damp or wet environments. Its primary benefit is a rapid-setting formula that allows for immediate pressurization of joints, significantly reducing downtime. However, users should note that due to its extremely fast curing time, precise alignment is required during assembly as adjustments cannot be made once the parts are joined.
All features
| Model Part Number | WETRDRY240 |
|---|---|
| Brand | Weld-On |
Extended Product Information
FAQs
Can I use this on pipes larger than 6 inches?
No, this specific product is designed for interference fits up to 6 inches in diameter. Using it on larger pipes may result in weak joints.
Do I need to use a primer with this cement?
While it can be used on non-pressure systems without primer where local codes allow, it is always best practice to consult your local building department or manufacturer specifications for pressure-rated installations.
How long should I wait before putting water back through the pipe?
The cement is designed to withstand pressure within minutes of assembly, but specific cure times may vary based on temperature and humidity levels.
Is this safe for potable water systems?
Always check the product label for NSF listing or local plumbing code compliance if the pipes will carry drinking water.
Can this be used on ABS or CPVC pipe?
No, this product is formulated specifically for PVC solvent welding. Using it on incompatible plastics will result in joint failure.
Troubleshooting
Cement has become too thick or gel-like
This indicates solvent evaporation. It is recommended to discard and replace the product as thinning with other solvents can compromise bond integrity.
Joint leaks immediately after assembly
Ensure the pipe was dry enough for a proper bond and that the cement was applied to both surfaces. If pressure was applied too soon, the joint may need to be cut out and redone.
Pros and Cons
Pros
- Ideal for emergency repairs in wet conditions
- Rapid curing allows for quick system testing
- Effective for both pressure and non-pressure PVC piping
- Includes built-in applicator for easier handling
Cons
- Very fast set time leaves little room for error
- Not intended for large-scale piping installations requiring long work times
- Strong solvent odor requires well-ventilated workspaces
Setup, Compatibility & Care
Before starting, ensure the pipe ends are clean and cut square. While this cement performs in damp conditions, excess standing water should be wiped away for the best bond. Apply the cement evenly to both the exterior of the pipe and the interior of the fitting using the included applicator. Quickly slide the parts together with a quarter-turn to ensure proper distribution of the solvent. Once bonded, the joint sets rapidly, so ensure alignment is correct on the first attempt. Always store the container tightly sealed in a cool, dry place to prevent the solvent from evaporating and the cement from thickening.