Everbuild Tile Adhesive - White 20kg

Yes, the C2FTE S1 rating and flexibility make it suitable for large format tiles, provided the surface is prepared correctly and the adhesive is applied evenly using a large enough notched trowel.

Yes, it is suitable for interior wall and floor applications, including wet areas like shower enclosures, once fully cured.

Refer to the specific mixing instructions on the product packaging for the exact water ratio. Typically, around 4-4.5 litres of water per 20kg bag is required, but always check the manufacturer's guidance.

Store in a cool, dry place in its original sealed packaging. The shelf life is typically 12 months from the date of manufacture. Check the packaging for specific details.

No, wallpaper must be completely removed, and the underlying plaster or surface prepared before applying the tile adhesive.

Generally, no primer is needed on standard substrates like concrete or screeds. However, for existing tiles or potentially problematic surfaces like unskimmed plasterboard, specific surface preparation or a primer (like EVERBUILD PVA BOND) might be recommended as per the product instructions.

Ensure the surface was properly prepared (clean, dry, sound). Check that the correct amount of water was used for mixing and that the adhesive was applied evenly with a suitable trowel. Ensure tiles were pressed firmly into the adhesive.

This may indicate excessive movement. Ensure timber floors are adequately prepared and ventilated. For general use, the added latex in this adhesive should prevent this, but ensure substrate rigidity.

Work in smaller sections, especially in warm or windy conditions. Keep the mixed adhesive covered when not in use. Ensure you are using the correct water ratio; too little water can speed up drying.