Bond It Spray Adhesive - 500ml
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for users of the Bond It Spray Adhesive - 500ml, providing a detailed overview of its features, uses, and care instructions. This multi-purpose adhesive offers strong, long-lasting bonding for various materials. Note that while it's effective, it's essential to ensure proper ventilation when spraying.
All features
| Model Part Number | BDA007 |
|---|---|
| Brand | Bond it |
Extended Product Information
FAQs
What materials can I bond with this adhesive?
It is suitable for bonding fabrics, wood, concrete, metal, plastic, rubber, paper, and card. It's especially effective for bonding foam to foam.
How do I use the variable discharge nozzle?
The nozzle allows you to adjust the width of the spray fan, giving you more control over the coverage area. Experiment to find the setting that best suits your project.
Is this adhesive safe to use?
The adhesive is free from CFC's and Methylene Chloride (Dichloromethane). However, always use it in a well-ventilated area.
How long does it take for the adhesive to dry?
Drying time can vary depending on the materials and environmental conditions. Generally, it becomes tacky within a few minutes. Refer to the product label for specific recommendations.
How should I store the adhesive?
Store in a cool, dry place away from direct sunlight and heat sources.
Can I use this adhesive outdoors?
While the adhesive offers a strong bond, its suitability for outdoor use depends on the specific application and environmental conditions. Consider the weather resistance of the materials being bonded.
What should I do if the nozzle clogs?
Clean the nozzle after each use. If the nozzle clogs, invert the can and spray until only propellant comes out. You can also try cleaning the nozzle with a pin or needle.
Troubleshooting
Adhesive isn't sticking
Ensure surfaces are clean and dry. Apply a sufficient amount of adhesive and allow it to become tacky before bonding. Check the compatibility of the materials.
Nozzle clogging
Clean the nozzle after each use. Invert the can and spray until only propellant comes out.
Weak bond
Ensure the adhesive is applied evenly to both surfaces. Allow the adhesive to dry for the recommended time before joining the materials. Consider applying a second coat.
Pros and Cons
Pros
- Versatile application across many materials.
- Strong and long-lasting bond.
- Adjustable spray nozzle for controlled application.
- Free from harmful CFCs and Methylene Chloride.
- Suitable for various industries, including furniture and automotive.
Cons
- Requires adequate ventilation during use.
- May not be suitable for all types of plastics.
- Surface preparation is crucial for optimal bonding.
- Can be messy if not applied carefully.
- May require multiple coats for certain applications.
Setup, Compatibility & Care
- Preparation: Ensure surfaces are clean, dry, and free from dust, grease, or loose particles.
- Application: Hold the can approximately 6-8 inches from the surface and apply an even coat.
- Bonding: For best results, allow the adhesive to become tacky before joining the materials.
- Compatibility: Suitable for a wide range of materials, but always test on a small, inconspicuous area first.
- Storage: Store in a cool, dry place away from direct sunlight and heat sources.
- Care: Clean the nozzle after use by inverting the can and spraying until only propellant comes out.