Dencon 15A Connector Strip - Pack of 10
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Dencon 15A Connector Strip is an essential component for electricians, hobbyists, and DIY enthusiasts requiring a reliable, versatile solution for joining multiple electrical wires. These 12-way terminal blocks offer the key benefit of being easily customizable by trimming to the specific number of points required for a project, though users should note that they are intended for low-voltage or specific amperage applications and require careful handling to avoid over-tightening the screw terminals.
All features
| Model Part Number | UTST6327 |
|---|---|
| Brand | Dencon |
Extended Product Information
FAQs
Can these connectors be used for outdoor lighting?
These strips are not waterproof and should only be used inside a sealed, IP-rated junction box if installed in an outdoor or damp environment.
What gauge of wire is compatible?
These terminals accommodate standard wire sizes up to 15A capacity. Always verify your local wiring gauge standards before installation.
Are these reusable?
Yes, the screw terminals allow for wires to be removed and re-inserted, provided the screw and brass contact have not been damaged.
How do I cut these safely?
Use a pair of side cutters or a sharp utility knife to cut between the terminal blocks. Ensure you are cutting on a stable surface.
Can they be mounted to a surface?
Most connector strips can be screw-mounted through the holes provided in the PE housing, but be careful not to crush the plastic.
Troubleshooting
Wire slips out of terminal
Ensure the wire insulation is stripped to the correct length and the screw is tightened securely against the copper conductor.
Screw is difficult to turn
Check that the screw is not cross-threaded; back it out entirely, realign, and slowly re-tighten.
Plastic housing is cracking during trim
Use a fresh, sharp blade and apply firm, steady pressure rather than sawing back and forth.
Pros and Cons
Pros
- Highly customizable by trimming the strip to desired length
- Durable polyethylene construction provides long-lasting insulation
- Cost-effective bulk pack of 10
- Standardized 15A rating fits common wiring needs
Cons
- Screw terminals can strip if tightened with excessive force
- PE insulation is flexible but can melt if subjected to extreme heat
- Does not provide strain relief for the attached wires
Setup, Compatibility & Care
Before installation, ensure the power supply is completely disconnected to prevent electrical shock. When trimming the strip, use a sharp cutting tool to ensure a clean edge; jagged cuts can sometimes interfere with the alignment of adjacent terminals. These strips are compatible with standard solid-core and stranded copper wire up to the specified ampacity. For maintenance, periodically check that the screws remain tight, especially in environments subject to vibration, which can loosen connections over time. Do not use these connectors in environments where the ambient temperature exceeds the rated limits of the polyethylene housing.