Wiska Cable Gland - M20 - 10065002
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Wiska EMSKV M20 cable gland is an essential component for electrical professionals and DIY enthusiasts requiring a secure, weather-resistant entry point for cables into enclosures. It is best suited for industrial or demanding environments where high-performance strain relief is critical, though users should ensure their specific enclosure material and cable diameter fall within the specified M20 size range before installation.
All features
| Model Part Number | 10065002 |
|---|---|
| Brand | Wiska |
Extended Product Information
FAQs
What is the cable diameter range for this gland?
This gland is designed for cables with an outside diameter between 6mm and 13mm.
Is this gland suitable for outdoor use?
Yes, the robust nickel-plated brass construction and EPDM sealing ring make it suitable for outdoor environments, provided it is installed correctly.
What thread size does the 10065002 model have?
It features an M20 x 1.5 metric thread.
Can I use this in extreme cold?
Yes, it is rated for temperatures as low as -40°C.
What material is the gland made of?
It is made of high-quality brass with a nickel-plated finish.
Troubleshooting
Cable slides through the gland after tightening
Ensure the dome nut is fully tightened. If the cable diameter is near the 6mm lower limit, verify that the lamella are properly engaging the cable jacket.
Gland does not fit into the enclosure hole
Verify that your enclosure features a standard M20 x 1.5 threaded port. If the hole is unthreaded or different in size, you may require an adapter or a locknut.
Pros and Cons
Pros
- Excellent strain relief thanks to lamella design
- High-grade nickel-plated brass construction
- Suitable for extreme thermal conditions (-40°C to 100°C)
- Includes an additional EPDM sealing ring for extra protection
Cons
- Specific to M20 thread sizes only
- Limited to cable diameters between 6mm and 13mm
- Requires proper tightening tools to ensure IP integrity
Setup, Compatibility & Care
To install, thread the gland into a standard M20 threaded hole in your enclosure. Use a proper wrench to tighten the gland body to ensure the EPDM seal is compressed sufficiently against the enclosure surface. Feed the cable (6mm-13mm diameter) through the gland and tighten the dome nut until the internal lamella grip the cable securely. For maintenance, periodically inspect the dome nut to ensure it has not loosened due to vibration. If the gland is ever removed, inspect the EPDM ring for signs of dry rot or cracking and replace if damaged to maintain environmental protection.