Permatex Plastic Weld Epoxy - Cream
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone looking to permanently bond various plastics, vinyl, and other materials using Permatex Plastic Weld Epoxy. It offers strong, fast-setting bonds, making it ideal for repairs and projects. However, it's crucial to remember that it's not suitable for polyethylene or polypropylene.
All features
| Colour | Cream |
|---|---|
| Model Part Number | 35222 |
| Brand | Permatex |
Extended Product Information
FAQs
What materials can I bond with this epoxy?
You can bond ABS, acrylic, PVC, fiberglass, vinyl, styrene, FRP, glass, and wood.
What materials should I NOT use this epoxy on?
Do not use it on polyethylene or polypropylene.
How long does it take for the epoxy to set?
It sets in 5 minutes and fixtures in 10 minutes.
What is the bond strength of the epoxy?
It provides permanent bond strength up to 3500 PSI.
Can I use this epoxy in high-temperature environments?
Yes, it has a temperature range of -51°C to 121°C.
Does it require a primer?
No, it does not require a primer.
How do I store the epoxy?
Store in a cool, dry place. Avoid extreme temperatures.
Troubleshooting
Bond is weak or fails.
Ensure surfaces were properly cleaned and prepared. Make sure the epoxy was mixed correctly and allowed to cure for the recommended time.
Epoxy doesn't set.
Check the expiration date of the product. Make sure the ambient temperature is within the recommended range.
Difficult to dispense.
Make sure the applicator tips are clear and not clogged. If the product is old, it might have thickened and become more difficult to dispense.
Pros and Cons
Pros
- Fast curing time
- High bond strength
- Versatile material compatibility
- Easy to use dual-syringe application
- No primer needed
Cons
- Not suitable for polyethylene or polypropylene
- Specific material limitations
- Requires careful surface preparation for best results
Setup, Compatibility & Care
- Preparation: Clean the surfaces thoroughly to be bonded. Remove any dirt, grease, or old adhesive.
- Application: Dispense the epoxy from the dual-syringe applicator, ensuring the correct ratio of the two parts.
- Mixing: Mix the two parts of the epoxy thoroughly.
- Application: Apply the mixed epoxy to the prepared surfaces.
- Assembly: Join the parts and hold them together firmly until the epoxy sets.
- Curing: Allow the epoxy to fully cure according to the product instructions.
Compatibility: Compatible with ABS, acrylic, PVC, fiberglass, vinyl, styrene, FRP, glass, and wood.
Care: Store in a cool, dry place. Avoid extreme temperatures. Clean up any excess epoxy immediately after use with a suitable solvent.