Supadec Industrial Grade Super Glue - 50g
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Supadec Industrial Grade Super Glue is designed for DIY enthusiasts and trade professionals who require a high-strength, fast-curing adhesive for demanding bonding tasks. Its primary benefit is its versatility and industrial-level durability across materials like metal, PVCu, and ceramics, though users should exercise caution as the rapid-bonding formula requires careful, precise application to avoid accidental skin or surface contact.
All features
| Brand | Supadec |
|---|
Extended Product Information
FAQs
Can I use this glue on plastics?
It is specifically formulated for PVCu and similar rigid plastics; however, it is not recommended for polyethylene or polypropylene.
Is this product heat resistant?
It offers standard resistance suitable for most indoor and light outdoor applications, but it is not intended for high-temperature industrial environments.
How do I remove the glue if I make a mistake?
If the glue has not fully cured, acetone or a dedicated super glue remover can help, though you should test on an inconspicuous area first.
Does it work on porous materials like wood?
While it can bond wood, it is best suited for non-porous materials like metal or ceramic where the bond remains rigid.
How should I store the bottle?
Store in a cool, dry place in an upright position with the cap tightly secured to prevent moisture-induced hardening.
Troubleshooting
Glue is not curing or taking too long
The surfaces may be too cold or damp. Ensure both materials are dry and at room temperature before reapplying.
Nozzle is clogged with hardened glue
Use a small needle to clear the dried adhesive from the tip. If the clog is severe, you may need to cut a tiny sliver off the tip of the nozzle.
Bond fails under load
Check if the surfaces were properly cleaned of oils or dust. Use an alcohol-based cleaner to degrease surfaces before attempting to bond again.
Pros and Cons
Pros
- Extremely fast curing time
- High-strength bond suitable for industrial tasks
- Works on a wide variety of substrates like aluminium and rubber
- Precision nozzle for clean, accurate application
Cons
- Rapid curing can be unforgiving if parts are misaligned
- Requires careful storage to prevent nozzle clogging
- Not intended for use on flexible or porous fabrics
Setup, Compatibility & Care
Before starting, wear protective gloves to prevent accidental skin contact. To apply, ensure both surfaces are dry and dust-free. Apply a small amount of adhesive to one surface and press the components firmly together for 10-30 seconds. For maximum bond strength, allow 24 hours for the adhesive to achieve full chemical cure. When finished, wipe the applicator nozzle clean with a lint-free cloth and replace the cap immediately to prevent the glue from drying inside the tip. Store the bottle upright in a cool, dry place away from direct sunlight to maintain the product's shelf life.